Icon Fitness Treadmill Reed Switch
Score By Feature
OveReview Final Score
Questions & Answers
The answer is yes, as stated by Nordic Track. Just so you know, speed sensors don't control the speed of a car. The only thing they can sense is motion. There is no return policy for electrical parts once they are installed.
My old treadmill with a "Proform" switch worked with the replacement switch. was incompatible with the old one, so it was spliced into the new cable with the plug from the broken wiring. Your repair will go well. Good luck.
Yes, I am. There is no problem with it
In my case, the diameter of the cylinder was slightly smaller than the one it replaced. The tape around it had to be wrapped around the existing hardware so that it could clamp to it. There is no guarantee that your mileage will be the same).
Selected User Reviews For Icon Fitness Treadmill Reed Switch
A few weeks ago, my Proform HIIT trainer stopped tracking steps intermittently, eventually not tracking them at all, making it The Reed switch replacement solved the problem, and it now works better than it did when it was brand The part was not too hard to replace, but a little difficult to reach inside, because I did not want to take apart the entire machine, but it was only about 20 minutes to replace Five minutes only.
To replace the reed switch on my brand new Proform HIIT H7 that would not function directly out of the box, I ordered this. It had a longer harness and a different connector from the one on my H7 that I was replacing, but I expected some differences since the part number wasn't a direct replacement for my H7. It took just a little trimming and some splicing and I was all set to use my H7. The long and short of it is that this switch worked perfectly for what I needed to use my H7.
There is a problem with this thing.
It is not clear if the reed switch was broken. This may be a problem with my machine.
Does the job like.
I was very pleased with the result. The cord length was correct and the plug was in the right place. Due to the cylinder being a little smaller than the original, I had to wrap electrical tape around it in order for it to mount.
Everything is fine with the product.