HHIP 3900-0133 Mt3 1" Morse Taper End Mill Holder-Drawbar End, 1" Hole Dia
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
Our MT2 and MT3 end mill holders have an 8mm center hole There are 16 threads on the drawbar end. In addition to the MT4, there is a 1/2-inch hole There are 13 threads at the end of the drawbar.
You can mount this on your drill press if it has a 2MORRISE TAPPER (2MT) spindle.
If you intend to use it on a metric machine, you will need to make a new draw bar
Approximately 3/8 - ON MT3, 16 THREADS ARE DRAWN
Selected User Reviews For HHIP 3900-0133 Mt3 1" Morse Taper End Mill Holder-Drawbar End, 1" Hole Dia
It seems well made. Putting a 1/2in dowel pin in the tool, however, only allowed it to go in a very small amount before becoming too tight to go any further. The tool I needed to use for securing the dowel pin did not go in at least a couple inches, which I needed for it to do its job. I found out it was a burr in the bore, and I used a 1/2in reamer to clean it up and make it a serviceable tool.
So be sure to check that your tool goes into the holder properly. Had I not had a reamer on hand to touch up the bore, it would have been a return and I would likely have given it a one-star rating. The Honourable John.
The tool holder is machined and finished to a high degree of quality. I've had no problems with it.
Much better quality than price compared to other products in the same category.
A good end mill holder can be found here.
I found this deal to be very fair and of great quality.
Exactly what I was looking for, excellent tool!.
There was something I liked about I'm an amateur machinist with limited funds (costs me less than two hundred dollars).
This tool holder is made of high-quality materials. The shipping process is very fast.