Onforu White Led Strip Lights 32.8ft, 600 LEDs Super Bright Dimmable Tape Light Kit, 6000K Daylight Bright Rope Lights, Flexible Strip Lighting with 2835 LEDs for Mirror, Under Cabinet, Home, Bedroom
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
This roll is 33' long
It is 1. Hi, it's 1. A 2m table.
Twelve dollars. You can purchase 10 connectors on Amazon for 99 cents each. The longest one you want is 8mm, although they come in different lengths. LightWill 2017 Updated Version 10pcs 2pin Single Color LED Strip Light Strip Connector for SMD 3528(8mm) Flex LED Strips Extension Cable for LED Strips, 1ft LED Strip to Strip Connector, LightWill 2017 Updated Version
Selected User Reviews For Onforu White Led Strip Lights 32.8ft, 600 LEDs Super Bright Dimmable Tape Light Kit, 6000K Daylight Bright Rope Lights, Flexible Strip Lighting with 2835 LEDs for Mirror, Under Cabinet, Home, Bedroom
There was only a 2 amp power supply provided with this kit. In order to provide 2835 LED lights, there is no requirement to power them. Each meter of lamps in the kit draws 4 amps or 10 amps for all ten meters. In other words, I expected the power supply to be able to supply at least 5 amps of power to allow for some reserve power. In some cases, the power supply provided by the manufacturer may provide inadequate power due to overheating, and a replacement may be required. The remaining five meters will be used with the power supply provided. We will use part of the lamps on another circuit and use the remaining five meters for use with the power supply provided. output of the provided power supply is 2 amps and the five meters will equal this. Combined with our infrequent use of the installation, this should not lead to an early failure of the power supply. Consider these things depending on the application you are creating. On Amazon, you can find a power supply that supplies 5 amps. We are very pleased with the dimming device provided. Neither the flickering nor the hum could be detected at any of the settings, but we did detect some "noise" at one setting. The "hum" was only audible at a distance of only a foot from the lamps. There was no option but to turn down the background noise at one setting since it drowned out the "hum. " In order to ensure the 3M lamp adhesive tape works, it is recommended that the surface of the lamps be cleaned with isopropyl alcohol prior to adhering them.
I installed them as usual and according to the directions. I use led light strips often. I needed the 33ft length so I ordered these from Onforu. It took 3 weeks for the lights to fail. They don't have an e-mail address on their website, which made contacting them impossible. Written warranties are not available from them.
Hope the others have a good day, too.
This is a highly recommended book. There is no doubt that this product is what it states to be. My 5 year old could have done this installation by himself without any assistance, and I was able to install it with ease. The warm white color still shines very well and does not create any glare on the TV when placed in a 13 x 17 foot living room. I have attached two images, one is taken at the lowest light setting, and the other is taken at 50%. There is so much light in the room that it makes the room look like a stage. I like touching it. The only thing I have left now is to figure out how to better hide the cords since I ran them along the ceiling and had to cram them through the wall to reach the outlets.
We noticed a huge difference in our kitchen after installing these lights! This is a great looking energy efficient chandelier. A total of 32 feet were sufficient for most of the kitchen cabinets, including the underside and top. I am amazed at how good it looks. I will tell you about the installation later. It's easy to fix with a hot glue gun even though the adhesive was terrible. This project was made possible by using quick snap connectors (and wire (gauge 22 AWG) from the hardware store. As well as that I installed a wireless light switch ( that controls the plug for the lights. Here we go! It cost around $50 for the whole project.
I am not certain where I would want the dimmer module, but I think the lights look great. The dimmer was located near the top (out of the way and out of reach) of my 42-inch wall cabs and connected to an outlet on a switched switch. A single wiring strip is easier to install, but I recommend the extra wiring kit if you require multiple strips. There were three different sections with which I had multiple connections. The sticky backing may not adhere no matter how clean the surface appears to be. Wipe it off with alcohol before applying the sticky backing. The solution I came up with was to add some 3M double-sided tape Use the tape and the small brackets of the separate install kit to attach them. In addition, if you are using a reflective counter top (like my quartz counters), ensure the strips are properly adhered so the reflection does not reveal that you failed to do your homework The wiring kit was a little light on information, so you should keep in mind that the connectors unclip on one side and unroll to allow you to slide the cut ends of the LED strips with the contacts under the tabs (it will make more sense after you get a closer look).
My experience with LED strips has always been that they are normally cool-colored rather than warm. I bought these as they were reasonably priced for the length and had a dimmer built in. I am working on a home bar project and these products worked great. As you can see from my images, I used it for a few different applications. An art project I created involved lighting up a stained glass window. With the lights installed, I was able to showcase the liquor bottles on my customized shelves. Using it to showcase the woodwork around the work counter and under the elbow rest on the outside of the bar came in handy. I loved the way it worked, easy to work with and to install, just make sure you buy the easy clips for the The timing of the installation means that we have not yet seen how well they last, but we hope that.
This is a very useful tool. In comparison to those with an IR remote controller (which is often defective and does not work), I prefer the simplicity of this system(just a dial for dimming and light levels). Since we first bought an IR remote control set, we have found this to be true. There was nothing I liked about it. This is the one I got in exchange for the one I returned. This is a better deal!.