AC 220V-250V 6A 60HZ 2 Pin Freezer Refrigerator Thermostat WPF-20
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
According to my understanding, it has only been designed for freezer use
A clockwise direction is cooler than a counterclockwise one.
As well as the ability to place a probe, you have the ability to select it. This might cause it to have an erroneous reading if it isn't pushed all the way to the end of the housing close to the evaporator. There is no refrigerator or freezer thermostat on it
Selected User Reviews For AC 220V-250V 6A 60HZ 2 Pin Freezer Refrigerator Thermostat WPF-20
In this case, it will cost you It was 99 delivered, so I had to give it a try. I used the part to replace the stock Kenmore thermostat #5304476700 it was an exact replacement The small chest freezer has a model number that is I measure 27 when set to a minimum setting. IDF to 4F An increase of 2F in temperature. We do not yet have any measurement data. The thermocouple temperature probe is exactly the right length. The male spade terminals must be filed down slightly before they can be inserted into the female spade connector. Screws go right in the mounting holes on a replacement, even though the mounting holes are threaded. This is a very exciting day for me. The thermocouple had to be pulled out of its hole about 6 inches in order to lower the temperature below 20s and get closer to 0 The size of an 8 inch.
I found it to be best for freezing and made the fridge colder than I This thermostat is a little different than my old thermostat, but it has worked fine. It might be a better choice for a freezer than a fridge. If you plan on using it in the fridge, it may need some tweaking. As much as I didn't want to believe it, my issue actually turned out to be a damaged gasket, which I was able to diagnose by installing my old thermostat. I installed it easily and it worked well, however the temperature is colder than I anticipated.
This thermostat was used to replace the one on a Black & Decker EV vehicle Stainless steel mini refrigerator from Decker. There was no listing for voltage other than 220V, so I was leery The voltage is 250V, which is 110V in the US An appliance that operates on 120 volts. I was pleasantly surprised to find that the thermostat worked perfectly despite my concerns. Having said this, there is one thing I dislike about the knob spindle. The flat side is 180 degrees towards the spindle With a Sharpie, I was able to draw an arrow and resolve the problem. It's not that big of a deal.
I like this one better than the original. In the freezer section, ice had to build up. It would then thaw in a tray below it. You'd fill it up with water and it'd get all over you. This issue is no longer an issue for me! This is fantastic news for me! It's a definite recommendation!.
An earlier version of this has been replaced by this There is no longer any stock of this numbered part. I provided my credit card information since the specs were identical in all key particulars. Amazon has the stuff you can't find anywhere else in less than a week that would have cost me $175 on a new refrigerator if I had paid $24 for the part Better than - A massive - There are metropolitan areas in the world.
A small adjustment to the thermostat corrected the problem. It was too cold right out of the box, but with a few minutes of adjustment, it was cold enough for a refrigerator. In addition to others' comments, the flat for the knob is not in the same spot as the original, so it may be worth adding new numbers. I used the knob in the middle of the range and adjusted the set screw until my thermometer registered 37 degrees Fahrenheit.
It's great to be able to use my mini fridge again. In my case, I replaced a WPF25J with this L. I knew this would be a gamble going in, but I was highly satisfied. The mounting, wire lugs, as well as the physical size, were all excellent. After the dial knob became loose on the new shaft, a small piece of old credit card was cut to make it tight once I used a Sharpie marker to make new markings to match the old model's position of the flat on the shaft they are 90 degrees out.
I received a small 2 cu ft Magic Chef brand "office" refrigerator for free, and found the thermostat to be refrigerator fits perfectly in my garage, and I now have a fridge for it. Plus it arrived 10 days prior to its expected arrival! Thanks a lot!.