SANNO Soap Dishes Soap Holder Soap Saver Soap Holder Soap Tray Bar Soap Sponge Holder for Shower, Bathroom, Tub and Kitchen Sink Black Nickel
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
It is important to note the following Be sure to turn the knob in seven circles to form the vacuum when installing the suction cups. In this case, the vacuum does the work rather than the sticky. It will be easier to place the suction cups if you use the sticky rubber. It is true that some old tiles seem smooth and shiny, but they actually have microscopic holes on them This defeats the vacuum as they slowly let air into the system. There may be a reason why some customers report big success and others fail. As far as adhesion to glass is concerned, the suction cups work fine. find out if your tiles are pliable for the suction cup, you can test the suction cups on any glass to make sure they are good or if they are defective, or if the tiles are pliable. The second paragraph. The surface of the wall should be cleaned and dried. 1. 2. 3. There is no need to disassemble the suction cups that you get. If you plan to tighten the knobs, ensure that you loosen them almost all the way before you begin. Ibid., p. 4. If the suction cup is rotated to lock, please rotate the cap until it is tight. This is 5. To ensure that the rubber surface is clean before the second installation, check it before you proceed. Otherwise, make sure there is no dust on the rubber's surface by washing and drying If this doesn't work, try The seller must be contacted for assistance if the suction cups are still not working correctly.
I personally would not attach it to a mirror even though it would be easier to stick to
Suction cup and screw assembly are chrome plated, the unit is made of stainless steel with a polished finish. I find this dish very appealing.
It is on a fiberglass shower which is fairly smooth but textured and about 20 years old, so the surface is not exactly smooth as glass. As I had assumed, it would have typical suction cups that would only stick to glass, and for a limited time. However, after I received it, I found that the cups had an adhesive that sealed the surface and prevented air from getting in. So I tested it on Since it has been on for a couple month, I check it daily to see if it is acting up, and so far it has not moved! My hand pulls so hard I think I may break it, so very good test. Apparently that adhesive/sealer on the cup makes a huge difference, and as long as your wall isn't porous or scratched, you should be just fine.
Selected User Reviews For SANNO Soap Dishes Soap Holder Soap Saver Soap Holder Soap Tray Bar Soap Sponge Holder for Shower, Bathroom, Tub and Kitchen Sink Black Nickel
I have seen several reviews about how it loses suction. An automatic translation tool has translated the instructions from Chinese to English. The following steps will help you This is 1. If you are going to stick to a surface, make sure it is solid and smooth. 2 Place the rim of the dish on the suction cup and turn the knob only one or two times. Turn clockwise (counterclockwise). The protective cover on the suction cup should be removed. •Br>4 Press the suction cup onto a clean smooth surface and hold it firmly. You may keep pressing the suction cup with one hand while turning the knob with the other until the knob is not able to be turned anymore. A strong vacuum is created when you turn the suction cup around and pull the middle of it towards you.
My disappointment is so great. I received the item just now. Observe the following after following the Cleaning the surface, placing the items properly, and tightening to the greatest extent possible did not stop the items from Over and over again trying to solve this problem without ever getting results is pretty frustrating. It is the first time I am writing a review on here because I am usually a happy customer. I detest the hassle of returning items because of the hassle of going to UPS or the post office. So in this case, I am.
Remove all dust and debris from the surface. It is to be used for the soap dish. It has worked well on porcelain tile over several days with multiple showers a day, two bars of soap, and strong suction! The plastic parts are of a good quality, although there were some broken ones. The outcome will depend on how things develop, but I'll note any changes to this rating. Take the time to thoroughly clean the surface on which it will be mounted after reading the instructions. Cleaning our tile (which is about 15 years old) with a tile cleaning product, letting it completely dry, then wiping it with rubbing alcohol and letting it dry for 15 minutes was all I had to do. When it is attached, the instructions instruct you to tighten it tightly and to let it sit for at least two hours without any load before tightening After my showers, I also double check the knob once in a while to be sure that a good seal has been maintained. My recommendation for this product is a strong one.
It is built in the shower of our 1970s-era house, which makes it convenient if you want soap to be sitting in a pool of water and constantly having water flow over it forcing you to replace soap far more frequently than you should. A perfect solution to your problem. The shower head can be easily mounted on the wall using this kit in less than It is easy to follow the directions. Make sure you clean the area where you want it to stick, then stick the soap dish to the wall and tighten it. When you have tightened a little, do so again. Until recently, the soap was getting wet. Now it stays dry, and the holder is not moving. The second one didn't go up as easily as the first one. I've bought an additional one as my first worked so well. Trying three times and failing twice to get it to stay was the only way to accomplish my goal. As far as the problem, I think it was purely user error, not the product. If it doesn't stick on the first try, rinse the black part of the adhesive that goes against the tile or surface to be mounted to, let it dry, and give it another try. You should be able to use it after a few hours. The two falls I have had since have been great, and I would love to get another one.
They're ridiculously easy to set up. 1) They get things done My two soap and razor holders did not come down and are stuck solid, holding my soap, razors, etc. Meanwhile, another razor stand that I kept (just for comparison) continues to fall. There's no end to how many times my husband puts it What's the reason? For the sake of a quick question, I was thinking "what the heck was that noise?", only to realize it was the old suction-type system. Once again, I was soaked to the skin by a cupped devil. The purchase here was a great one and I recommend it highly I recommend it. As a sidenote I like the way they look!.
The purpose of this purchase is to replace another soap dish with plastic suction cups that I bought on Amazon. My problem is that I only use shea moisture 8oz bars of soaps and the first two weeks of trying out a new bar of soap leads to a lot of loud falling in the tub, constant sliding off, and it does not Compared to other products, this one is larger and stays in place. My personal recommendation for suction vacuum products is very strong. I have posted a couple pictures to show you that they work for me and stay in place. There should be no sliding or falling Make sure the knob is turned as tightly as possible.
9% of the reviewers lately at Amazon are only those who want to leave negative comments! The good news is that despite the negative comments, even after going through the reviews, I felt that this soap dish was inexpensive enough to take a chance on, so based on how it appeared and where I wanted it, I chose this one. My tile guy forgot to install the ceramic soap holder I had purchased to accompany the tile that I had installed in the wall of my tub after I had my bathroom gutted and remodeled in an art deco style. When I searched for a mountable soap dish that would fit nicely in my art deco/ 1920s themed bathroom, I found one on Amazon. The layout of this one caught my eye, and I loved the look of it. According to reviews, a lot of users claimed that the wallpaper wouldn't stick to their So despite what I read, I ordered it - it showed up on my front porch in a day and a half after I ordered it, I carefully read the easy directions (anyone who complained about the broken English instructions not making sense, has never understood English as their native )
After following the instructions to a tee, I had no problems getting the soap dish to stay on my wall since I discovered it had been delivered, unboxed it, and read the The lemon squeazy method is easy, peasy, and fun! I bumped into it with my knee while showering and it didn't come off! It holds the weight of my soap bar, does not come off when I steam in the shower, and it doesn't fit in any of my bags! You need to follow the instructions in order to have it stick! Use gorilla glue if you are unable to follow instructions. Basically nothing complex here it works, it sticks, it's not rocket science.
Features an attractive design and is functional.