Simrad Micro-C Backbone Kit, New Condition, 000-10760-001

As long as your go9 has an NMEA 2000 interface, you're good to go. My go9 SXE is equipped with an NMEA 2000 interface. I used the adapter for the NMEA 2000 Backbone to connect my Yamaha 06 to my Go9, and now I have access to all of my engine data.

To finish wiring for the transducer and external antenna, you must order the installation kit.

This is how I have it set up. My GPS/Sonar unit is a Simrad GO7. It can show engine information as well as a variety of other information. I have a Merc 150 four-stroke engine. To connect the Simrad to the Engine, I needed to purchase the N2K backbone, as well as a Merc Gateway module that connects directly to the motor and the N2K backbone. My Simrad now displays all of the engine data. A T connector will be required for each individual sensor to connect to the N2K. Trim tabs, fuel gauge sending units, AIS radios, and AM/FM modules, for example, all need to be connected to the N2K in order to be displayed on your GPS unit. I hope this has been of assistance. Chris V., a.k.a. Chris V., a.k.a. Chris V.