Lenco 15504-101 Auto Glide Aftermarket Kit for Single Actuator

Trim tabs and cable connectors are interchangeable. The solid state trim sensors are housed in a separate control box that must be mounted near the display/control unit (which will fit into the same cut-out). out). The cables connecting the display and the control unit are pre-cut and included in the kit. The power connector is a standard Deutz connector that works with existing Deutz units. I upgraded mine, and it's a simple process if you have a suitable location for the control box (which is new in the Auto-X). version that glides). On installation, the website is very comprehensive. It's well worth the investment, and mine works flawlessly once properly set up (which is simple).

It can be used with either 12 or 24 volts of power. The voltage is automatically detected and adjusted by the module.

The system will not function without GPS and NMEA 2000. Because some boats already have a GPS and NMEA 2000 network installed as part of their electronics packages, this package does not include them. The speed is measured using GPS, which allows the Lenco system to adjust the tabs as needed. The NMEA 2000 collects data from the electronics and the engine (via a gateway) to determine how to adjust based on RPM. As a result, it is dependent on what is already installed on your boat.