ASUS ROG Strix B550-I Gaming AMD AM4 (3rd Gen Ryzen Mini-ITX SFF Gaming Motherboard (PCIe 4.0, WiFi 6, 2.5Gb LAN, DDR4 5100+ (O.C.), Front USB 3.2 Gen 2 Type-C, Addressable Gen 2 RGB and Aura Sync)

I plugged it in and it I did not have to mess around with the RAM and reseat it or anything fun like that. It seems to work perfectly in an NZXT H1. I'm not sure what to do with my life now.
Put it in an NZXT H1. It is still early to test all the functionality, but I will update you as soon as possible. I was getting about 420 Mbps down with AC wifi, but I don't have a lightning connection. The AMD 3700x processor provides a comprehensive set of features Using a 1060 6GB chip it computed the result Sabrent TLC nvme was displayed There was a storage unit.

Jovanni Finley

| Jan 08, 2021

of all, it is my pleasure to say I have been a devotee of Asus ever since I built my first computer ten Several key aspects of this motherboard fall short of my expectations. Upon receiving my first board, I returned it because the chipset temperature went up to over 90 degrees C under load, and to an idle temperature of around 75 degrees. Despite the fact that the CPU and GPU are air cooled, I found them to stay extremely cool even under load, so there was no issue with airflow. Compared with the first board I received, the second is a far superior product, although the chipset is still THE hot component (it can be found running around 75 degrees C now when under load, while the GPU runs towards 75 as well, while the CPU is mid to high If they are using poor quality thermal pads or not getting the heat sink as tight as they should, I would guess either the thermal pads or the heat sink are not as good as they should be (I tightened the board to confirm and found one of the screws was looser than I would have expected). * * 2. I also have a problem with the rear IO shield on the board. Since the USB C ports in the rear do not lock nearly as tightly as a regular USB port, any cable that you insert will push out of the foam filled rear IO port, so I will have to cut down the rear IO shield to fit my It would be best if Asus had had the USB C ports stick out a little so the cable can be inserted with a little pressure from the IO shield if they were going to go this If I had it to do over again, I would have returned my first board for a refund and purchased either a MSI board or an ASRock board (Gigabyte boards do not have a front USB C header, so what I'm suggesting doesn't apply to me). This board was tempted to be returned a second time due to the USB C problem, however it is so hard to reassemble a small ITX board that it did not seem to be.

Rebecca Garner

| Feb 09, 2021

I got SOLID PIZZA when I booted it for the first time. I had the option of either F2, or DEL, in order to access the UEFI BIOS. There were no responses when I pressed these keys. It did not work when I re-set the CMOS. The CMOS battery was unplugged and the CMOS was reset again, with no apparent result. I then decided to put a new BIOS file on a USB stick, plugged that in, turned it on, and I was shocked to find out how well it worked! Getting to the BIOS was the last step. A flash of the BIOS was then attempted. My "security verification failed" message happened from a file that I downloaded DIRECTLY from ASUS's website. After that, the PC froze, shut down, and now I don't even get a post-boot An LED glares at me from afar. It is the first time I have had this bad of an issue after building a lot of machines. In spite of the ease of the build, it has now become This is the most recent edit My ASUS motherboard did work with my components after I switched to a Gigabyte. This confirms what I noticed, that the problem was definitely with the motherboard. I will never buy another ASUS motherboard again.

Leilany Burns

| Aug 21, 2020

Prior to starting my build, I preemptively cleared the CMOS and BIOS memory. It is a simple task that should be done with every brand new motherboard, yet one does not always remember to do it. The loaded profile/timings from the installed memory during testing might still remain on your computer, which could result in conflicts with your particular setup because they have been put through QC testing. The chances of it being placed in such a situation are less). you should consider whether this might be an issue for you and do your own due diligence. It's hard for me to assess how much weight and validity these critiques have, and I believe its phase configuration is appropriate for its B550 - my experience with it With an I Gaming system, Corsair Vengeance LPX 3600mhz CL16 memory and an XFX 3700X are selected. Three out of three is a great combination. As well as the Samsung PM981 M I added. Taking advantage of the dual NVMe SSDs provided by this board, it boasts a heatsink design. You could build a very similar build, sans choice of GPU, by using that hardware, if you're trying to build a similar Xbox Series X build. In light of the GPU shortage, the system is currently housing an RX 580 8GB while it is being tested, but soon a 1080 Ti that I have in my other system will be installed. In part, I am an agnostic double-atheist in part, I am a libertarian When it comes to hardware vendors, they act as agents. In the past few weeks, I have not encountered a single issue with the configuration, and it has been 100% stable. However, I noticed that the XMP profile is not loaded by default (that's usually the case with most motherboards, but I have seen them load automatically in the past), so be sure to do some changes to your BIOS under the Ai Tweaker section. The purchase was all in all a good one.

Millie Bird

| Nov 23, 2020

This $300 pile of crap is worthless. The computer won't boot past the bios and I'm highly annoyed by it. A stock of MSI should be available.

Boston Benson

| Mar 19, 2021

In spite of installing this mobo along with my other components, I received an error message when trying to boot into Having checked the memory, hard drive, CPU, etc. for hours, the problem ultimately came down to the motherboard. As an end-user, I had to clear the CMOS, which was relatively easy to do, but as a brand new product, Asus should be more aware of the quality control of their products. The PC works great now that it is booting up, and I am happy to hear that my rig is working again. It has been a long day of troubleshooting for you,.

Ensley Henson

| Mar 03, 2021