Fractal Design Meshify C - Compact Computer Case - High Performance Airflow/Cooling - 2X Fans Included - PSU Shroud - Modular Interior - Water-Cooling Ready - USB3.0 - Tempered Glass Light - Blackout

There is actually a slight difference in length between this case and most mid-sized premium cases You may be able to fit this case in a variety of smaller areas in your room due to its tower design. Although the length of the case is smaller, I was still able to fit a full size EVGA RTX 2080 XC ULTRA graphics card AND a H150i pro 360mm AIO from Corsair in the front with half an inch to spare. This is amazing! With the aid of a removable bracket near the front of the case on top of the sleek power supply shield, the 360mm AIO can be supported, and there can be a total of six fans. In the top section, the fans are located so they are adjacent to the side panel, allowing you to fit 120mm fans without interference with your motherboard. However, even if you tried to fit two 140mm fans up there, you might run into problems. In the front of the case, there is a mesh that allows the front fans to breathe almost completely unhindered, and it looks very cool. The fan speed of my 9900k is low and the pump power is balanced. As a result, my 9900k runs at only 72 degrees C. In terms of cable management, this case is not the best I have seen, but it is certainly not There is ample room for the majority of large cables to fit into the channel on the left side of the back panel and since I have RGB fans, it once looked like a spaghetti monster until I managed it. Besides eight SSDs on the back of the motherboard tray, you can also install up to five hard drives if you don't use a 360mm radiator as I do.

A great case that looks great and is easy to build. Recommend it without a doubt!.

Jonas Snow

| Dec 29, 2020

There are no precedents for this case. going to do an air drill, make sure you If you have a cooled build and need a compact case, this one is In addition to Meshify, NZXT is also frequently considered, however the Meshify C gets a huge edge over NZXT due to the front of the case being entirely mesh, thus allowing for In addition to the mesh on the sides, the top and bottom of the case are mesh-covered Since dust can be screened out, dust should be a relatively minor issue for this case provided you have positive air pressure by blowing in more air than is being blown It is ridiculous when you consider how small it is that you can mount up to seven fans in this case. I-*- *- On the front It's possible to have two 140mm files or two 120mm files. With the detachable hard drive cage removed, this size is increased to 120mm. I-*- *- In the top A pair of 140mm or a pair of 120mm-br> A rear view. A 120mm piece of paper x1* At the bottom You will need to remove the detachable hard drive cage to have 120mm available. A solution for the management of cable is found in the placement of holes and tie-in points A neat look is achieved by rubber grommets securing the down points - This is what it looks like I appreciate being able to use the device without having to worry about it falling off or snapping apart. There should be no doubt about it There were no problems at all at all when I took the case apart a few times and walked around with it stuffed with 30+ pounds of computer components. The only thing I am not happy about is the lack of accessibility to the front panel compared to every other part of the case. Also, there are several cables connected to the front (for the power button, reset button, USB port, and headphones port) that could be damaged or broken if you don't remove the front panel carefully. Then I can dock a star - but it's not enough for me to do so The problem should not pose a significant problem as long as you observe safety procedures.

Ari Cook

| Dec 31, 2020

With this case, you can get as compact as you can for an ATX motherboard. This creates some challenges for cable management, but clever design makes it possible with some Filters that prevent dust from accumulating This case has dust filters at the front, the top, and the bottom, which is an impressive feature. I consider it one of the best options for a PC that sits on the floor, though I would still recommend pointing the power supply fan upward rather than straight Compatibility with the following drives In this case, I have no less than five disks installed 1. two 2. three There are two 2" desktop hard drives and one 5" desktop hard drive. There are two 2. 5" laptop HDDs and one 5" laptop HDD. SSDs with a 5" form factor. There's one more M you can add. It is possible to have 2 SSD's in the same case without taking up space, but only if your motherboard is compatible with that. Please keep in mind that you should never use ANY right This is the best case for angle SATA cables, as they will work well with the mounting. Flow of air Probably the biggest selling point of this case is the airflow, and I can verify that the case It's not necessary to stuff it with fans, because unlike most cases, it doesn't have a solid front panel obstructing the airflow, so each fan is able to breathe All in all, it appears that this case met all my needs to a perfect degree. One small nitpick is that the power indicator is not RGB, so unless you unplug it, you may end up messing up your color scheme.

Sofia Morales

| Mar 04, 2021

The pros include The ATX mid-tower is much more compact than most other ATX devices. Tempered glass is a type of *Good air flow is important. Cable management that is second to none. It is compatible with radiators up to 280mm in diameter. *Includes 2 fans of 120mm each. The cons are the radiator up front, some graphics cards may have a harder time fitting in there. I can barely fit my EVGA SC Black GTX 1080 Ti in my case. If your hard drive cage includes an A/C, it can be removed in order to add a compact power supply (which is fine if there is not a There is no need to mount more than two drives, since you can mount three. The motherboard has five drives behind it). The I have replaced the included fans with Noctua fans, which I find to be very quiet, but also very expensive (in my case I have two 140mm fans on the EVGA clc 280, two 140mm on top and one It's easy for finger prints to stick to tempered glass.

Colter Taylor

| Aug 16, 2021