Echogear in Wall Cable Management Kit - Includes Power & Low Voltage Cable Management - Hide TV Wires When Mounting A TV - Includes Hole Saw Drill Attachment for Easy Install

The kit contains everything you need, and the instructions are simple to follow There is no doubt that the finished installation is excellent. There was an oversight in design as the cord makes it impossible to place furniture flush against the wall, and since the entire point of this product is to have a clean look, that seemed like it would be a design flaw. As a result, I purchased a low-cost Describe your experience with the profile cord separately (enclosed are before and after photos). It's now possible for me to attach the dresser directly to.

Bryce Chung

| Jul 08, 2021

I am glad I opted for this one. With this kit, you'll have the ability to put together the same thing for much less cash than you would by purchasing component parts from your local hardware store (old work electric box, face plates, etc) ***** - It was mainly because of the power situation that I chose a kit. There is essentially nothing in this kit that needs to be changed It is very easy to manage the extension cord on the wall. A grommet is used to attach the male and female ends, and a panel and screws are used to attach the male end. Here is some information for your reference Carte options, you will have to get a loose extension cord or a long cable that runs from the TV to the extension cord, which is another wire that needs to be fed through the Another benefit of the kit is the fact that the complete cord is already made for you, so you don't have to make any bare-core wires The connections between the wires. There's even an extension cord they include so you can end up near the power source after you finish using it. The power problem has been ***** - Additionally, I was concerned that there may be too many wires that can go When I asked, they said there were four, but I was able to squeeze in more Among the cables we had, we had four HDMI, one bulky RCA cable, and one smaller audio cable, all CL2 or CL3. I find them all to be fairly comfortable to wear. doesn't seem like there is much space, but when you take the face cover off, there is a little bit more room. (You need to do this in order to reach the screws that hold the wall to the shelf. ) With this extra room, you are able to pass the cable ends through the grommet, while the face plate helps corral the cable bodies a little. You should run all your cables through the grommet before you attach the faceplate, so make sure you do this. ***** - In addition to looking great on the wall, this kit is also quite attractive! After it has been installed, it has a very sleek and modern appearance. The faceplates you'd find at the hardware store are far inferior to these. ***** - Also, installing the grommets was fairly easy. The drill attachment of my drywall saw cut a hole that fit perfectly into the grommet, and they very easily screwed into place. I am very impressed with this kit it is great on the inside and out.

Mariah Baker

| Jan 08, 2021

In less than 15 minutes, I was able to install this product. I was able to do it with my own drill in a straightforward manner. The HDMI cables and cable and Ethernet cable are connected here along with 1 fiber optic cable and a coax cable. It's about as far as you can go. You may be liable for a void in your homeowners insurance if your cable is not rated for in-wall use (CL2, CL3, Plenum). Here is an awesome tip Although that was the longest part, fishing the cable through the wall wasn't that bad as well. In the event you have insulation, investing in fishing tape is a great idea! The fishing tape should be fed up the hole from the bottom to the top. Through a hole on the fishing tape, thread some twist tie wire or zip tie around your cable in a tight band. Pull the fishing tape down with the cable in it, then the fishing tape up. This is a lot easier than doing it the other way around. Is there a reason why 5 stars aren't available? These face plates are made out of plastic that snaps on. It might be easy to break this thin plastic Therefore, your cables should be connected on the first try. The second paragraph. The screws holding the ear flaps on are attached to the sides of the plate if you need to remove them. In that case, you might unscrew them so far that they fall straight down from I saw Echogear's product and thought you should make the screws longer and then put CA glue on the tip after the wing is inserted. Your customers will not have 2.
At least 1 ten-foot width is needed. It would have been nice if HDMI CL3 cable was available. If the HDMI jacks were female to female and the ethernet jacks were female to female, then this would have been a true premium product. Not only would that be cleaner, but it would also eliminate having to rewire anything. In case the cable needs to be replaced, fish the wire through the wall. Unlike cables behind walls, cables behind walls are rarely moved, so they tend not to go bad. It is common to see cables bent on wall mounts. A bad connector can cause data loss.

Clyde Vargas

| Dec 31, 2020

There is literally everything you need to make the holes and install the kit inside the All the hole covers adhere tightly after the installation is complete. The product does not have to be connected by electrical wires like some other competitors' There is no catch it is a breeze. I installed three areas (kitchen/dining area, kid's room, and wife's home office). In the wife's office, I ran two HDMI outputs from the TV into a separate HDMI dual output wall plate for ease of use instead of running cables directly to the back of the TV (see photo). This is a great product and I would definitely recommend it and use it again for other installations that don't have it now There are hidden cables and wires inside the wall I had four computer monitors mounted in my home office. The price is more than reasonable and customer service is great (although I did not need it) as they reached out to see if I needed help or if I had questions, and offered to get in touch if needed. In an era when most product suppliers want to sell and disappear if you ask for assistance, that's hard to beat. KING CHARLES.

Karsyn Levy

| Sep 20, 2020

The materials used for this wall power kit are solid and the design is nice. It was very easy to install, except for the hole drill bit that stripped out, so I had to finish cutting the holes with a drywall saw I already had on hand. Otherwise, it went really well. I should mention that if you have a Samsung Smart TV, you will likely have to use a short indoor extension cord to plug it into the TV because the Samsung power cord I have runs horizontally to the plug it's attached to, which prevents it from plugging into the TV.

Layne Lamb

| Jan 02, 2021