1 Port Ethernet Wall Plate -VICTEK - Cat6 Ethernet Cable Wall Plate Female to Female Compatible with Cat7 Cat6 Cat5 Cat5e - White…
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
As far as I know, not at all.
You are more than welcome. So long as you have access to a LAN switch or injector, as well as CAT5E or greater cable, you're good to go. Neither of these will cause any problems with the relay.
Your ethernet cable will work as long as it is an ethereal cable.
Your best bet would be to buy a single port wall plate (or a device like this 2-port wall plate ), as well as an inexpensive ethernet hub (15 cents). In this manner, four or more devices are connected to whatever device is on the other end of the wall plate (e.g. Use a router or cable modem to connect to the internet). Because the hub is a powered device, it must be plugged into an electrical outlet.
Selected User Reviews For 1 Port Ethernet Wall Plate -VICTEK - Cat6 Ethernet Cable Wall Plate Female to Female Compatible with Cat7 Cat6 Cat5 Cat5e - White…
As far as the plate itself is concerned, it's There is no point in using those screws. Turning the screws requires a screwdriver head that has an indentation large enough for the head to reach. It only took me a half-hour to get them in before they were ripped. In fact, the screws I bought at Lowe's went in without any trouble. Be sure to grab screws when you go to the store.
Despite having the tools I could have installed it myself but I had an electrician friend do it for me. Assembly is not difficult at all. In order to fix the hole in the wall, you fix the cable on the back of the plate, then you screw the plate into the drywall to secure it. Plugging in from outside with another cable is all that's required.
I liked it a lot!.
This can be seen on the internal wall - Rather than using a standard faceplate, I'm using a custom-made one The cat6 cable was crimped and I used a premade cat6 cable as the outside cable. This project worked flawlessly on the first try. The only 10gig networking I have is on either side of a gigabit switch, so I cannot comment on 10gig connectivity.
There is not much else I can add. I am amazed at how well it works. You just need to run an Ethernet cable between the two ends and connect them.
If the cable is connected in a low angle, the connector is cheap, but loses continuity. case, the box is knocked out near the bottom. As a result of this low angle and broken continuity, it breaks In order for the unit to work, I needed to turn it upside down.
It is equipped with a female connector on both ends, so those who have standard cables can use it.
It is a good match and fit that the screws provided are provided.