THE CIMPLE CO - 3 GHz High Frequency Ground Block - Single Port - Weather Seal Boots for Coaxial Cable, Coax F Type approved for Antenna, Satellite Dish, Cable TV - One Port Grounding - 1 Pack
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
I attached a ground clamp to the antenna mast and ran a 10 AWG wire to a ground block near grade level, then another 10 AWG wire from the ground block to the electrical service's existing ground rod. The 10 AWG ground wire was the smallest size recommended by an antenna manufacturer I found online. line, but I believe that a 6 AWG ground wire would have been a safer and less expensive alternative. This is most likely going to be a change I make to my setup.
It can be installed on a wooden floor. This is why two wood screws are included. The green screw is used to thread a 6 gauge copper grounding wire through the hole. Following that, the grounding wire must be properly grounded according to NEC code.
We use a high-quality alloy body with a brass and gold center conductor, UV-resistant Rubber Grommets, and a high-grade brass and gold center conductor - All of them were created with high frequencies (3GHz) and low loss in mind. SCTE Outdoor certification is given to the entire block.
8 gauge is also suitable.
Selected User Reviews For THE CIMPLE CO - 3 GHz High Frequency Ground Block - Single Port - Weather Seal Boots for Coaxial Cable, Coax F Type approved for Antenna, Satellite Dish, Cable TV - One Port Grounding - 1 Pack
I can't comment on its grounding abilities because they're difficult to test, but one important feature I can confirm is that it allows power to pass through. I have a preamp (a Winegard 200) connected to the antenna, with a USB power supply inside, and this grounding block in the middle. The amp is powered by the power supplied by the coax cable and this grounding block.
The coax ground block I received is not the same as the one shown in the listing. The one I got has only one grounding screw (in silver) and a blue connection center. Two green grounding screws and a yellow center are depicted in the listing. br>br>For a visual representation, see the attached image. br>br>NEW ADDITIONAL INFORMATION - After I contacted CIMPLE CO, they fixed the problem. The second block appears to be identical to the listing image. It's of higher quality than the one that was initially sent. The installation will take place this weekend.
It's made of solid metal and feels good in the hand. br>* Includes mounting screwsbr>* Gaskets are large enough to cover cables when tightened and insertedbr>* Includes two grounding posts that can handle up to 10g wire.
Grounding block of the highest quality. Grounding block and screws are heavily plated, and the grounding screws and block are heavy duty. The weather boots on the connections are easily and non-slip, so this should last for a long time. Easily destructible by simply rotating them away from the female F- connective tissue They were unnecessary because the male ends of my coax were already equipped with weather boots.
I needed a ground block for my OTA antenna and looked in Lowe's and Home Depot but couldn't find one. They had ground-attached splitters, but no ground blocks. This accomplishes its goal and appears to be well-made. If you're installing an outdoor antenna, this is a must-have.
Because I'm not an electrician, you should include a sister product that contains all of the necessary components to complete the installation- - Use proper grounding wire and so on. and not even 50 feet away from it. It'll suffice to get this up and running.
The coax cable from the roof-mounted television antenna is attached to one side, while the coax cable from the television to the inside is attached to the other. A grounding wire is attached to it and leads to a grounding rod driven into the ground just below it. The weatherproof rubber protectors are attractive and comfortable to wear.
Because of the rubber insulators built into the block, it is far superior to my old grounding block, which had corrosion build up over time due to exposure to the elements. I believe I could have just attached it to the side of the house and been fine, but I decided to put it in a sealed plastic box for added security. This is going to be a long-term project for me.