Thread Kits (1208-102 Thread Repair Kit
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
There are 12 weeks left in the year The kit comes in 24 pieces.
Rather than in inches, these measurements are in metric. The diameter of a millimeter is approximately It is about 10mm when you multiply 040 by One inch equals 400 points.
Selected User Reviews For Thread Kits (1208-102 Thread Repair Kit
The included tap wrench is nice since it can be obtained for no additional charge. My research told me that the pitch and dia of the fuel bowl screw thread were correct for the (Holley) fuel bowl screw thread, so I purchased a 15/64" tap wrench and a drill to complete my kit, rather than forking over their $81 kit.
Looks like he's up to the task. This is a very basic concept. A fine drill bit needs to be designed by you. It is a near size because I didn't have time to find a proper size. No box for storage to allow for frequent use so maybe a Plano container to store them. My part was fixed. It should be repairable again and last for a long time.
Amazon is the easiest way to buy threaded inserts since local hardware stores have a small selection. I was very pleased with this tool set and the inserts as well. It was affordable and the delivery time was very quick. It is not a complaint. Easily disposed of the ruined mess left behind by the notorious "previous owner"!.
Having a thread repair kit on hand was essential to repairing threads that were stripped on a carbon fiber mast. Although the kit doesn't come with a drill, it specifies a 13/64ths inch drill bit which is familiar, as is a 1/4 inch thread drill bit. *The helicoils in the description were somewhat magnetic even though they were described as stainless steel. My next step is to test if they As for the star rating, I'll go with 5 stars if they don't.
This is an excellent To go with it, make sure you have or buy a 15/64 drill bit. Two of the threads on the carb bowl/body for Holley carburetors 950 cfm stripped out, so I used the helicoils. In light of the fact that they were at the rear, I simply did all four. The last time that I stripped was years ago.
Added a new coat of thread sealant to a Holley carburetor. This screw holds bowls together.
My Ruger 10/22's threaded take-down screw hole was stripped and I used this to repair it. I found it to be easy to use and it worked!.