Unlimited Rider M8 8mm Secondary Clutch Spreader Belt Change REMOVAL Tool For Can-am MAVERICK COMMANDER OUTLANDER RENEGADE ATV's & SXS's, Metric Bolt M8 x 1.25 x 70, 12.9CL, Pre oil, Fully threaded

Unlimited Rider M8 8mm Secondary Clutch Spreader Belt Change REMOVAL Tool For Can-am MAVERICK COMMANDER OUTLANDER RENEGADE ATV's & SXS's, Metric Bolt M8 x 1.25 x 70, 12.9CL, Pre oil, Fully threaded

$ 8.99

Score By Feature

Based on 533 ratings

Customer service

9.05

Satisfaction

8.61

Packaging

8.81

Giftable

8.77

OveReview Final Score

How Our Score Is Calculated

Product Description

There are twelve features to this product. It features 9 CL, pre-oil, a fully threaded design

The size of the card is The following are the dimensions of 25x70 bolts

For Can-am ATVs and SXSs, this is the tool used to open the secondary clutch

This will not fit the factory X3 spreader, because they use an even

The 70mm bolts are THE PERFECT length (open the clutch completely, but will not allow overthreading or increased stress on the clutch springs).

Questions & Answers

Do you know if it will work for the ?

That is not a logical reason for it not to. The belt change is usually the same regardless of how the belt is set up according to the model year. The setup should be almost the same as long as the belt is changed at the same place.

Do you think this will work for a CAN-based system What do you think of Defender Max XT HD10?

Four-wheel drive). Using this tool has made spreading the discs easier on Commanders and Mavericks. There is a very good chance that it will function for you even though I have not tested it yet. buy this, make sure you thread the chain on by hand to ensure it works properly and do not use an impact to hammer it on until you're sure

If they're sold individually or in pairs, how much do they cost?

A bolt is used and only one threaded hole is present on the secondary pulls the other two don't have threads

Do you have the Odes 800cc for ATVs?

You should be able to use it as long as your odes 800 has a M8 x 1 spigot. Bolt size of 25 x 70m can be made by AMSA

Selected User Reviews For Unlimited Rider M8 8mm Secondary Clutch Spreader Belt Change REMOVAL Tool For Can-am MAVERICK COMMANDER OUTLANDER RENEGADE ATV's & SXS's, Metric Bolt M8 x 1.25 x 70, 12.9CL, Pre oil, Fully threaded

This is junk

3/5

This is junk. It arrived on time and I did not expect it to be so poor in quality. As I was threading it all the way in, I applied a small amount of pressure and the bolt snapped. It stripped the threads on the aluminum when I backed the bolt out. The only way I could give negative stars is to do so!.

Cohen Kaufman

| Jul 01, 2021

There is no problem

5/5

After I got it to work nicely, I could not find where I put it so I went to the hardware store and bought.

Kiaan Burch

| Jun 24, 2021

How to install a clutch bolt belt

5/5

It has been awhile since I bought it, but I finally moved forward to use it to install a new belt on my Can-Am Side by side, an Am Maverick did what it was supposed to do. It was much easier to install the belt with it.