Baomain Car Toggle Switch SPDT Latching (Maintained) ON-Off-ON 3 Pin 3 Position 12V 25A with Waterproof Cover for Auto Car
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
Yes, you can just all depends on how and what your wiring consists of
My bilge pump was controlled by this switch and worked well.
Selected User Reviews For Baomain Car Toggle Switch SPDT Latching (Maintained) ON-Off-ON 3 Pin 3 Position 12V 25A with Waterproof Cover for Auto Car
There are various female leads available (you need 1/4 inch) and the type of wire you use will affect the size of the leads you require. A wide wire size range is critical, but there are only a couple of different groups of different gauges like 16 gauge to 22 gauge or below 16 gauge. The bigger wire sizes take a considerably different lead than the smaller sizes for just the reason that they break at 14 or 18 gauge. In order to prevent plugging up the tabs (sticky out male things) to one another, I prefer insulated leads. In the case of an uninsulated female connector, they would be able to touch each other. An alternative would be to wrap the tape around the item.
The light bar was connected in this manner along with a relay so the light bar could be turned off, on, or high beam. I would buy this product again if I had to thank you for it since it's easy to use good build quality.
Turn on your computer or turn it off. I was satisfied with the results. In my case, I used it to power the center pole. My left light is turned on when I flip the switch to my left, and my right light is turned on when I flip the switch to my right. I think it is very well made and the rubber coating seems to be of high quality.
It is not possible to screw on rubber boots. There is a plastic washer barely attached to the bolt that I believe is supposed to be held by one of the nuts. Taking off the washer will make it easily break and makes it in no way It may be easier if it is mounted straight up and down.
It is perfect for my use as a fuel pump and fuel filter The ignition kill switches are set up at the ignition. The first two have been used more will be bought. The quality of the film is nice.
Making my own tilt/trim switch for my 40 hp outboard was a lot cheaper than buying one from a name brand. A person just needs the gumption to take action. I am happy with how things are going so far.
Install was easy and the product was sturdy. A bilge pump is currently being used.
The product is excellent. I would buy it I think it's well built, with a rubber cover presumably to keep it from getting wet.