Belltech 6200 Lowering Block Kit
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
There is no way that will work on your 1969 C10. Instead, you need rear lowering springs!
In this listing, the part number is "6200" from Belltech! A block that is 3" high. (F/X Motorsports) does not currently carry any other block kits, but I am sure you can find a different size right here on Amazon if this 3" does not fit your needs!
Those products listed in item number 6200 do not fit the 2009 Hummer H3.
Selected User Reviews For Belltech 6200 Lowering Block Kit
This is a real 3" lowering block by Bell Tech, as follows The list of which includes you The bolts, washers, and nuts fit perfectly on my 2001 S-350 There is nothing worse than the picture that betrays the fact that the vehicle is a 2010 Blazer, two doors, two wheel drive. You may mark the post as "helpful" if you found it useful.
On freeways, 3 inches is perfect for not bouncing, but you need to remove the differential bump stop and remove the space about a half.
There is an issue with the top pin on the blocks as its too high and is not properly seated. There are far too few U bolts on both sides. I managed to get one on each side, but they're hanging by a thread. I don't recommend it at all. I would rather the bolts be too long than too short. I installed them on a 73 Datsun 620 pickup truck.
9 horsepower There is almost no room for improvement. A 1999 Dodge Dakota SLT v8 with the heavy duty tow package is in our possession. A little bit of an adjustment is needed. It was an u-turn In order for the blocks to be secured securely, the bolts should be an inch longer. As a result of the washers, the nuts tighten so that the bolts are only half-tight You will have to turn the nut all the way through. Axle, block, leaf springs, and lower plate are all too far apart to be fastened together with a single bolt.
Bolts of the wrong width were installed on the 2003 Blazer 4x4 with a S10 body. Two Blazers have been injured A tube with a diameter of 3/4". I hope Belltech can do it right soon. This is a bummer when they can't.
There was a problem with these U bolts. They are 9 inches long and I had to purchase 10 1/2 inches. I have bucks.
Rides much better now that the truck has been repaired!.
There is a mistake on the product photo. Belltech 6200 lowering blocks and hardware are 3 inches wide. My tires went in my truck easily, and I dropped them down just over 3 inches. In addition to this set, I also bought a set of monroe air shocks, so I can still haul stuff. I like these a lot. The product is great! I highly recommend it!.