Standard Motor Products EGV1149 Standard Valve Sensor, Oem Replacement, Emissions & Sensors

I have fixed my issue, so I no longer have a The service I have received from Standard Motor Products has been excellent. There have been EGR valves from this company that have been faulty, but none from other companies. There was no return of the CEL after it was fixed. Be sure that the carbon tube is completely clean before you reassemble it. For this, we suggest you use brake cleaner and shop rags, along with a small flathead if necessary. In order to clean the carbon tube, I roll a blue shop cloth around the corner and feed it in the It would be better if there was some kind of small snake that looked like this. You can use an air compressor to blow the clean end if you have one. Put a rag over the dirty end and press it against the air compressor. A dirty carbon tube can ruin your new part or cause a CEL on its own. (don't forget to rub it with a rag, it could blow stuff everywhere)

.

Oakley Medina

| Jul 08, 2021

There's not much to say, just solved the EGR position codes on our 2010 Chrysler Town and Country The metric system. It is necessary to have the right sockets and extensions to avoid having to remove other components A small amount of sensor safe RTV/exhaust gasket sealant was applied after cleaning the mating surfaces on the motor, and anti-corrosion spray was applied to the whole thing We have to deal with it for the time being). Everything was included in the kit, and I just replaced the old bolts with the new ones. I've been using it for several months without any problems so far.

Frances Doyle

| Sep 10, 2020

Having this egr sensor installed as a replacement for a busted original one on my 2007 Jeep Wrangler worked great. Due to the tight space in which the bolts are located, the installation was extremely difficult. However, looking up an installation video on YouTube made the installation seem simple. I got the engine light to go off and the code to disappear as soon as I had it connected and bolted up. This has been on for about 3,000 miles now without any issues, so I am pretty happy with it. If you are looking for a fair priced and good quality EGR sensor, this is a good choice.

Sara Calhoun

| Dec 16, 2020

It looked as if it were the I cannot replace this part without a lot of difficulty. I got a half drive 10mm socket and that was the trick. It was only this way that I could apply enough torque to break the bolts at the rear.

Ayaan Delgado

| Jun 03, 2021

I couldn't have asked for anything better. On a 2008 Chrysler Town and Country Mini Van, it is pictured. received a check engine light for no apparent reason and the code revealed that the oxygen sensor was malfunctioning. A replacement for the OEM I purchased appeared within a couple of days and was a direct replacement. During the install, the engine light went off by itself and it took just a few minutes total. It would be a good choice to read.

Mariah Glass

| Oct 13, 2020

It is possible that your results will differ. The Jeep worked fine for about four months, then it began to stall and skid. The vehicle was taken to the Having replaced the throttle body and the O2 sensor, the car ran great for a few miles, then stalled and skipped. Since they removed the EGR, the engine was running normally so they replaced it with a new EGR, and that has been the case ever Apparently someone had a bad piece of the pie, even though others have done much better.

Miguel Gonzalez

| Jul 30, 2020

O'Reilly Auto almost sold me one, but theirs was consistently bad with many failures. Getting along great on this one so far!.

Anya McCoy

| May 04, 2021

If you search online for videos, you'll find a few videos that show you exactly how to do this repair. It is completely possible, you just need to be patient and be able to save a ton.

Maria Sherman

| Sep 18, 2020