HIGHROCK 5 Kit 2 Pin Way Car Waterproof Electrical Connector Plug with Wire AWG Marine
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
My drill bits have just been busted out so I drilled a few holes for you to test. A half inch hole will not be able to fit this male or female. A 3/4-inch hole is large enough to let me fit the male. A female will not be able to make it to It will not work for the male if it is smaller than 3/4.
If the wire gauge matches the wiring harness (which should be the case), then it is consistent. If you splice well, that's all that needs to be done.
There are five packs in this set
It's possible the connectors have heat shrink on them, but I have not noticed. In any case, these connectors are not submersible. These connectors, based on my experience, are weather resistant. No advice would be given regarding submersibles.
Selected User Reviews For HIGHROCK 5 Kit 2 Pin Way Car Waterproof Electrical Connector Plug with Wire AWG Marine
Their flaws, however, need to be addressed. They are not waterproof, so I take that back. It is nice, however, and the pieces seem to be well put together. In addition, the plug itself is sealed with a waterproof gasket. Not all of the wires leading to it are protected. The problem was rectified with the addition of a dab of silicon. You can now wear them without worrying about getting wet. It was possible for the manufacturer to include this with the plug and charge an additional dollar.
At each terminal, a silicone seal is crimped on, and a second seal is situated It is possible that the plastic components are made by AMP On the male connector of my unit, there was an AMP terminal lock. A lip is provided on the wire end of each connector, so you can wrap some large heat shrink tubing around the wire end to seal locking tab is easily released due to the soft and pliable nature of the plastic. I like the way the crimps are on each terminal.
In order to connect and disconnect my outdoor water pumps, I have been using those clear plastic terminal block screw connectors. With the terminal blocks getting rusted, and carrying a screwdriver with me all the time, I decided to try this. First of all, as for the 'waterproof' claim, yes, I would say After keeping them submerged in water for 24 hours, I connected them and tested them The connectors do not contain water. However, I find the performance of these connectors to be insufficient. There is a reason for this, and it appears to involve the wire size of 20AWG. There has been a drop in voltage of 10 points. In the eight to tenth grade I pass 5 amps through them when they are rated at 4. As a result, the heaters get very hot, and the voltage falls even My advice to you would be to avoid using these in your The use of lights has been suggested by some I would say that one connector is needed for each 18W Those days are over. Take a moment to consider where all of In the listing, these are not stated what type of current they can handle. Thus, I have given these a low rating. To a question in March 2016, the seller responded by stating that the wire was 10 AWG- This is absurd. In the event that you need to connect light loads completely waterproof, these will work. We will try some 'terminal block spring connectors' and we will see how that goes. Make sure they are out of the rain as much as possible. In the image above you can see them in the picture next to some 20 gauge speaker wire. I received a response from the seller within a short period of time The refund came through quickly and I wasn't able to complain. As I am still running these, I didn't need a refund, not a full one anyway. Right after they deleted the misleading Q/A, they added a new one I am gone. However, if you decide to use these for anything other than 18w LEDs, ask the seller what gauge the wire is, otherwise you may burn out the LEDs. The batch they received mid 2016 appeared to be a bad one.
The 73 Shovelhead is also known as the It was essential to have reliable connectors when rebuilding a 73 shovelhead and these fit the bill. I am extremely happy with the quality and the fit. It was important for me to be able to connect and disconnect various items easily, Since I live in Seattle, these are frequently exposed to moisture, and their quality has never been compromised.
The information states that it is suitable for marine use, but without a doubt, this is not the case. The connectors were purchased about a year ago, and now I have to replace every single one. In terms of the wire connection itself, it seems solid, but the opening going into the boot is enormous. By doing this, water gets into the inner seal, causing it to corrode. Although it was not intended to be used underwater, I used it inside the kayak's hull. As a connector, it takes care of the job. But it will definitely not work for marine applications.
It's a good thing I am still using it.
The LED project I did on my motorcycle worked perfectly with these. I liked the quality of the wire. The first few times were a bit challenging but after a few cycles they became easier to separate and put back together again. Due to the fact that they are under my seat, I cannot speak to the waterproof factor. To be on the safe side, I chose waterproof.
This was my third order of this Idem.