Dorman 625-829 Turbocharger Oil Line for Select Buick/Chevrolet Models
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
If you can cruise in 2011, then it's a yes
You are right, it is a good fit.
You can count on it.
There's no such thing as a hex bit, but rather a hex socket. They are sold by the set. A local parts store should be able to assist
Selected User Reviews For Dorman 625-829 Turbocharger Oil Line for Select Buick/Chevrolet Models
It cost the dealer 700 dollars to complete the job. It cost me less than $40 to do it myself thanks to Amazon. When dealers go to bed, how do they get some sleep?.
According to the internet, this product would fit my car but the indications are conflicting. I turned out that it was a millimeter or two too long. In order for both ends of the cable to fit in their respective holes, I had to bend it very slightly before installation. Screw the threaded end into the gasketted end straight before putting the threaded end into the gasket. I was surprised that it fit but it did. We haven't noticed any leaks. Since the original turbo line original had a smaller hex hole, you're going to need a 10mm hex bit to screw this particular item in.
I am satisfied with how this fits my 12 Cruze Eco Turbo 4 is a four-cylinder engine. There were double o rings in this part and a heat shield around it that required replacement. The first gm is all. We needed 4 turbo engines replaced but there wasn't a recall on them so we were happy that it went for a good price.
The system is leak-free. It may just be that it's brand new or because it's short, but you need to work on it a bit to make it In order to install the oring, install the hex nut side first.
The fit is great, but there was some bending required for the hand. Since the turbo inlet on the factory turbo is torx, but I received a hex adapter, I gave 4 stars.
As a replacement, this is a good part that is cheaper than the stock part. An image shows how the banjo bolt looks in real life, and it is not the same as the stock bolt. The problem is definitely not that big if you have the right tools (it was the largest allen wrench I had). In addition to the fiberglass shield, I also wrapped the whole thing in duct tape.
I'm very pleased with how this part fits! Take a paper towel and place it underneath the part next to the screw if it leaks it's this part this is a 40$ fix do not bring to the dealer or mechanic at the shop it only takes 5 minutes just make sure you have a start bit and an.
They are a bit cheaper than AC Delco parts, so I save while having the same level of.