Omix-Ada 16533.08 Axle Dust Shield

On the bottom, there were a few spots that weren't painted at the factory. The unpainted areas had some surface rust from sitting in the warehouse unpainted for a long time. I had to sand them down and paint them with Rustoleum high gloss paint to make them look better. It only receives four stars for this. Aside from that, it fits well and is a good replacement, so if you're not afraid to touch them up, they're a lot better than the old rusted out skid plate on my 79 CJ5.

Treasure Pearce

| Aug 18, 2021

It's comfortable to wear and does the job well. When you replace axle seals and/or bearings, these should be replaced as well.

Antonio Hodges

| May 03, 2021

It was a well-constructed part. It appeared to be the same as the original OEM part and fit perfectly.

Louisa Stanley

| Oct 05, 2021

Dust Shield is comfortable to wear and lasts a long time.

Sevyn Rivas

| Oct 02, 2021