Vertical Bulb Trim Seal Bulb Diameter: 0.5" Grip range: 0.039" to 0.14" | Trunk, boot, lid, hood, hatch rubber (5 Feet)
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
Measure in metric units instead of inches
An area that grips and a diameter that has a gap will be different in their durability
There is no need to remove the glass if it is framed. Your glass should be able to go on if it has a naked edge. It may not stick to the glass however when the window is opened.
Not at all
Selected User Reviews For Vertical Bulb Trim Seal Bulb Diameter: 0.5" Grip range: 0.039" to 0.14" | Trunk, boot, lid, hood, hatch rubber (5 Feet)
In my RV, I used this as a seal around the vents. The replacement from RV retailers over the internet on through dealerships is much superior to that from RV retailers off the internet.
I have replaced the old K&N with a new unit and it works pretty well A tear caused the trim to be cut. I would recommend this book without hesitation.
It was purchased to install on an aftermarket intake system There is a good fit between the strip and the thin sheet of Moreover, it took me a very short time to cut it.
My Dodge Grand Caravan is now equipped with this system!.
It seems to be a good idea. I couldn't get my application to stay in place in one direction for whatever reason. I had to flip it 180 degrees to get the work done. What about durability? The future will tell, but so far everything seems to be going well.
Strong product that does what it was advertised to do. On my track car, I used it to seal the top of a custom airbox to close up the hood so hot air didn't get inside. Since it took some elbow grease to apply, this should also ensure that it will stay in place.
To seal the window in the Truck cap unit to my tailgate, I had to install a rubber gasket. It is 100% efficient at preventing water from seeping in and even helps secure the window's closure and lessen vibrations. It is extremely effective to use the grip pocket. Initially, I planned to use silicone caulk to help the gasket stick, but eventually determined that this was not needed at all.
Great product for replacing the bed end gaskets on our 1977 Apache Mesa pop-up This is the perfect fit.