Edelbrock 7201 Intake Manifold Gasket - Pair

$ 20.99

Score By Feature

Based on 239 ratings

Customer service

9.26

Delivery

8.97

Packaging

9.32

Giftable

9.35

OveReview Final Score

How Our Score Is Calculated

Product Description

Due to the silicone beads surrounding each drilled hole, a complete seal is assured

An excellent seal can be achieved on rough, irregular flange surfaces with gasket material

Under load, provides a minimum recovery rate of 30%

By compressing the gasket, any imperfections on a sealing surface can be filled

There are no end seals in this kit and Silicone Sealant should be used in place of them

Questions & Answers

The engine will be on a 64 Belair I have with the Edelbrock intake manifold 2701. Is it also compatible with the 327 engine?

That should be the case. This is what I am going to put on my 327 in my 1967

Selected User Reviews For Edelbrock 7201 Intake Manifold Gasket - Pair

However, it doesn't include everything that is pictured, and it does not come with all the gaskets that it did come with

3/5

The thing is a bunch of However, it doesn't include everything that is pictured, and it does not come with all the gaskets that it did come with. According to the instructions, you must make your own seals for the front and rear doors. It comes with only the two main gaskets, the distributor gasket, and the sealing ring (only three of the seven items pictured).

Nyla Vega

| Feb 15, 2021

The product was good, but the shipping wasn't as shown in the In the kit I obtained, there was only one distributor gasket and the two intake gaskets, it did not include any rubber ends or water necks

4/5

The fact that it contained what I needed (the two intake gaskets) is fine, but I dropped a star because what I received wasn't as described. Here's a tip if you get the two rubber ends, throw them away right away unless you want oil to leak out. Rubber end gaskets have never held oil in the past. Simply apply Permatex Ultra Copper RTV to the ends of the gaskets to finish the job.

Christopher Morgan

| Jun 21, 2021

A set of Edelbrock manifold gaskets

3/5

It didn't fit very well on my Chevy 350 Small Block After trimming the tops of both valve cover gaskets, I had to adjust the valve cover mounting locations. As a result, I had to remove the water passages and replace them with a FelPro gasket set that worked great - I was disappointed that RTV had to be applied around them to stop them from sucking water out of the engine. After any extra work and time spent, it was necessary to remove them and replace them with the FelPro Gasket Set - which required a great deal of extra effort and time. It's too bad Edelbrock didn't live up to my expectations!.

Marleigh ALLAN

| Nov 24, 2020

There will be no more purchases from me

3/5

The picture on the right shows only a few of the gaskets that were delivered. Only two gaskets came with the kit, and they did not fit properly. There is no way I would recommend these gaskets. It was especially tough since we bought three trucks, one of which was There is no way I will use them, although I will buy more to replace them.