Taylor Cable 51046 Plug Wire Set, 1 Pack
Score By Feature
OveReview Final Score
Product Description
Selected User Reviews For Taylor Cable 51046 Plug Wire Set, 1 Pack
The LS swap headers are used for the swapping operation. 45 degrees is denoted by a 45. Clearing the headers is done perfectly by boot. This is 6. (0-LQ4 with headers from speed engineering The tube is 7/8" long).
In order to swap our LS headers, we had to ensure our piece fit perfectly. are great for the job.
It was a gamble since they were so cheap and I wasn't expecting much from them. They are a great wire set, and I was very happy to see them. I would strongly recommend it.
It is just a matter of being careful about placement and making sure manifolds don't They melt really easy, and they're angled right around the manifold tubes, so they're in close proximity to them.
On a 6, I ran for one year. I put 500 miles on the zero and then it misfired. I found 1 wire that was 20,782 ohms while comparing to the rest which were 440 at the time. Taylor's has always been a favorite, but I'm now apprehensive about it.
I can clear my tight headers, dipstick tube, wraps, and heat socks even though it is on the long side.
I also liked their angled boot on the plugs, it gives you a solid area to pull them off without pulling out the terminals.
There is a 45 degree bend at the plug, which is different from the stock wires. This means that the wires are slightly long. This means you cannot use the metal insulators that came with the vehicle. As a whole, the quality seems to be.