ASPL 2x16.8 inch Emergency Flashing LED Traffic Advisor Strobe Light Bar 32LED 26 Flash Patterns Interior Safety Warning Lights (Amber)
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
It is not serviceable since LEDs are hardwired to the circuit board and cannot be replaced. However, if you're highly technical and possess many years of soldering experience, it can be done with extreme care and is not for the faint hearted.
Pattern 1 out of 26 should be the correct answer
It is not possible to sync both lights. They are both controlled by one switch.
I am not sure if any are listed, but I know there are many to choose from.
Selected User Reviews For ASPL 2x16.8 inch Emergency Flashing LED Traffic Advisor Strobe Light Bar 32LED 26 Flash Patterns Interior Safety Warning Lights (Amber)
In my job as a freelance journalist, as well as for my work at roadside assistance, I purchased these lights several months ago. Now that I have had these lights for just about 4 months, I can say that I am mainly satisfied with them. I particularly like how easy they are to plug in and play, since they were brand new when I It would be better if the suction cups were of better quality and would not eventually fall off when Having mounted them externally on my 2021 Rav 4, I found the LEDs to be okay, they would have been better if they were brighter, but they are bright enough for most nighttime work. I used the mounts that came with the device for a brief time, but they are fine. As for mounting the screws externally, it is highly recommended that you put some form of rubber glue or similar on the screwheads if you decide to go that route. The lights have begun to rust. Overall, this is a good set of lights for a beginner.
In a nutshell, I have no idea what happened to the suction cups, but the lights are amazing. To attach the glass, I removed the suction cups and flipped the side L brackets so they'd sit flush with the glass. I used some 30lb mounting tape to secure the glass in place. It would be cumbersome to have the suction cups by the middle of the window, if the cups worked. A glass tint of 18% is applied during daylight to the video window.
The windshield of my Mazda CX- 5 was purchased for the windshield of an EMT After purchasing the Amber/White, I decided to switch to the Red/White. I installed this towards the top of the windshield and ran the wiring across the top, sides, and glove compartment until reaching the socket, which was neat and looked like it belonged there. With a tidy installation and very few wires visible, there's no need to install anything extensive. Due to my car being a lease, I can remove them without permanently altering the vehicle. The different options of light patterns is very helpful to choose one that works for your needs I chose one that I liked because it was so intense. It feels as if the lights are made from very high grade materials, and they are heavy because of that. While the suction cups provided are of very good quality, they may not stay on your windshield if it is especially curved. To get the suction cup to work as it should, you should place it on a flat surface. If you place it on a curved surface, the suction cup won't work The left side of the shirt was installed properly so it didn't fall down, but my 2 year old ripped it off one day so I was never able to get the right side properly attached. Until I can replace them, I will let one corner of the light bar rest on top of the rearview mirror for support.
Overall, I am super happy with these lights and highly recommend this brand if you are searching for this type of light bar.
An 8-inch LED traffic advisor that you can see at a low price. In a nutshell, As part of my efforts to prevent being run over on highways while helping others, I have this lightbar and other ASPL products with me. There is a nice and flexible cord on the cigarette lighter of this traffic advisor and it is bright and strong. A long time. In addition to this bar, I have a pair of deck lights at the rear of the house as well as There is a magnet mount bar on the roof that is 5 inches wide. It helps to use different flash patterns and different height levels on different types of lights in order to make traffic pay attention. Having better warning power from the longer bar than the smaller 12 or 15 inch bar that is usually found on construction vehicles makes these ASPL products an impressive offer in quality and price. We need to emphasise the warning power in the ASPL products.
In a nutshell, This is a very high quality light and I am very impressed. My truck's back window and the front seat of the door of my truck fit the stickers perfectly. In the winter, I use them while plowing snow. Superb lighting makes them stand out. Rather than hardwire them I hard wired them to a momentary switch and a When you cut off the cigarette plug, you'll be able to do that because of the three wires. A red, black, and yellow color scheme. A yellow line indicates a momentary state.
Polaris Crew Ranger owners can order these to install on their vehicles. In my mind, I wanted one facing forward and one facing backwards (we use it on the job, of course we are often on the side of the road). But there isn't enough cord between the two lights to make that work. Consequently, I had to use both of them on the back. Aside from that, these are a good set of The only thing I can say about durability is that I only have them a couple of weeks, so I won't be able to speak on the durability, but I'll report back in a few months.
Very pleased with the bars, however the suction cups in the package were deformed due to the way they were packaged. There were three suction cups that were impossible to adhere to my window and the bar constantly slid down without sticking. My glass surface was exceptionally clean after I thoroughly cleaned my glass to ensure I could salvage the second cup. Amazon replaced the item so I could salvage more cups. I like the length of the cable. There is a multitude of patterns in the lights, and the lights are strong and bright. It's just that the suction cups are not strong enough to hold the glass securely in place for non permanent installation. In order to get it to work, I had to wedge the thing upside down into the molding around the rear window.
You frequently have to clean suction cups to keep them on the windshield, but they are powerful. Their brightness and efficiency make them an excellent choice for commercial use. It's kinda hard to see them through my %5 Window tint during the day, but I can get through them at night since I spend most of my time outside. It was not possible to mount the lights with the suction cup mounting hardware that came with them, so I had to make my own way to mount In spite of the price, they are a good value. However, there is a serious lack of.