Morris 90636 Direct Burial Ground Rod Clamp, 5/8-Inch

It is essential to achieve the following two things for a long-lasting connection *1) MOVEMENT OF THE WIRE STRAND In certain situations, the strands are forced to slide sideways across the rod and against each other, removing the oxide and exposing fresh, shiny metal for excellent connections. Almost all clamps have a vee-shaped opening Besides helping keep the wire round, they reduce sliding by having shaped edges where they touch the wire Unfortunately, things have not gone well. Unlike other clamps, this one has a rounded profile that allows the strands to glide past the rod and each other as it flattens out to form a good 1) DISTENTION In order to form an airtight seal that won't corrode or oxidize, the strands must be compressed and deformed against the rod and each other. LOADING IT UP WITH FORCE. Apply as much pressure as you can without breaking the clamp to deform the copper so that it connects to the airtight point. When the clamp breaks through the thin section around the bolt hole, it usually damages the bolt and the bolt itself. Instead of a cylinder around the bolt, the top of this Morris clamp is solid, so the area around the bolt is reinforced and there is more torque available. There is no limit to how many you can take. The hydraulic lug crimpers forge metal strands into one solid wire.
3) A wonderful safety feature is the short bolt, which ensures that the clamp won't break when the bolt is tightened all the way and towed. There's no need to get it this tight, but if you tighten it through the contact point until it hits, then it's a solid connection that will never fail. Additionally, this applies more pressure to big wire.

Both the sides and the top are machined to eliminate pits that could start a crack, and the surface is finished in an attractive way. My cordless impact driver, which is rated at 900 in-lbs. , should theoretically be able to If you have 75ft or more of land, you can apply lbf This is an abstract term for the right brain By a great deal more than the minimum of 30 feet With a hex socket adapter and the movement of the rod, it is possible to get the length down to less than 10 feet in practice A small amount of lbf came close to squishing the wire and forming a good connection, but it wasn't close enough. To get a 1500 inch screen, you'll need the following The job will be done with a lbf rating, or maybe even Having been saturated in alcohol and penetrating oil for 40 years, my flooded and rusted up old 3/8" Chicago Pneumatic air impact wrench will still break a clamp at 4, so I turned it down to 3 and well and truly eliminated the clamp issue Despite this, these clamps have a neat feature, they don't break thanks to the short bolt.

Regina Mercado

| May 04, 2021

It worked great. Although I purchased three, I only had a need for It was incredibly easy to install them and they worked so well!.

Sydney Riddle

| Jan 10, 2021

An axle clamp is attached to a bolt. They wouldn't have been able to screw this up as readily as they did.

Lyric Roy

| Feb 05, 2021

The item came exactly as described. I was able to get it quickly and it Besides the great price, the quality is great too.

Londyn Barrett

| Apr 11, 2021

They are great, so buy one.

Karla Price

| Dec 21, 2020