Ensenior 12 Pack 4 Inch Ultra-Thin LED Recessed Ceiling Light with Junction Box, 2700K Soft White, 9W 75W Eqv, Dimmable Can-Killer Downlight, 750LM High Brightness - ETL and Energy Star Certified

Several of us wanted to add recessed lighting to our kitchen and dining room. Based on the following The LEDs are daylight colored, have a flush mount, and are easy to install. My research included local hardware and lighting stores, as well as everything available on the Internet. I chose this 12-watt LED bulb This package was the best value for money since it met all our criteria. My order arrived in good condition and all the lights were working. Having tested each of the lights, I found that their brightness, output, and color temperature were all consistent. It was a bit of a challenge getting it installed, but it all went well- This is not due to the lights, but rather to the nature of the installation Designing and laying out the space correctly is key (as is predicting where beams and obstacles are located) and cutting clean, circular holes in the sheet rock that fit the design. Cutting the holes from the sheet rock It is recommended to have six holes for these lights. It was not possible for me to find a standard circular hole cutter for my drill that measured 1 inches. There are several adjustable attachments available, but they are almost As it turned out, I wound up using an oscillating saw with a hooked blade that worked well, but I was unable to make the circles perfectly round, which caused me to have trouble installing the lights. When installing the lights, I had to use a box cutter to fine tune the holes. One good thing was that I hadn't made any of the holes too large. Despite its simplicity, the wiring was straight forward. I liked the way in which the devices were daisy-chained together Putting the lights in chains- All you need to do is strip the wires of each light, then plug them in the terminal blocks that come with the power supply. Worked great and took just a few seconds. The springs on the lights caused me to remove one star. There is a bit of a problem with their size and they are very tight. I had a difficult time fitting the lights into imperfect holes because the plastic clips kept coming off. After trying to reattach the plastic clips repeatedly, I finally just gave up and found that the lights fit just as well without the clips. This was the only flaw, and it is relatively insignificant since it has no effect on the lights' performance at all. As a whole, I am very pleased with the project outcome. My wife says her kitchen and dining area look so bright and cheery! The fact that she is happy makes it all worthwhile ).

Fatima Berry

| Oct 10, 2020

My company is run by an electrician and I own it myself. The LED trims that I buy when customers want recessed lights are usually commercial electric LED trims, but whenever there isn't room for a normal recessed light, I buy these and they've never failed. Having these can lights in your recessed area is a great way to make your room look amazing. I strongly recommend them to anyone who needs recessed lighting. All of the lights are sleek, with most of the body being glass with a one-inch rim around it. It is possible to install these lights anywhere and they will look great. There are 16 of these lights around the back of my house and so far none of them have burned out. I installed them 16 years ago. In case anyone is looking for recessed lights, these are the ones they should In addition to the short distance between the wires, the quick connect connectors make the installation of these recessed lights much easier than the use of.

Amber Perez

| Jun 24, 2021

They flickered on some of the dimmers I installed them on (I think there were 16 of them). was told it must be a dimmer that is approved by the manufacturer of these lights, so I had to discard those dimmers and replace them. The world will not end due to a nuclear accident. It is the support team from the manufacturer who contacted me and helped me analyze the problem, and even offered to walk me through the various elements to identify which ones may be flickering, to ensure that the system doesn't flicker I have at least the assurance that if I were to order this brand again, I would have been helped if necessary by their unparalleled.

Jacoby Weber

| Mar 27, 2021

It's been over a year since we built our home. We did not choose to build a tracked home, but rather a custom home built by a builder who takes on both spec and custom jobs. During the time it took to decide on lighting, we walked the house with the electrician and discussed the options personally. Upon reaching our kids' bedrooms and the guest bedroom, the electrician told us that he usually just installs a light along with a ceiling fan. When we asked if that was sufficient, he told us it was, and he kept it in his Despite our concerns about the budget soaring, we accepted the offer. As soon as we moved in, we were so disappointed with the lighting in the kids' rooms. A lamp was required in addition to the ceiling fan light, but the rooms were still dark I discovered these lights one day when I was living with it for a year. Adding LED lights, my greatest concern was that I might run into a truss, and therefore have to cut a new hole and patch the previous one I had already made. As far as the ceiling was concerned, it looked like a mess. Because these lights are so thin, it goes without saying that if you hit a joist or truss when installing them you will not have a The sheer thickness of the drywall allows them to fit inside. Even though I am not an electrician, I understand the wiring in household appliances. It took me just a few minutes to install them, and I fastened them to the existing wiring in the ceiling fan, so when the fan light is switched on, all the lights turn It only took me a few hours per room to do these myself. It is a good idea to have a hole saw that is 4-inch wide It measures 1/8 of a meter or 105mm We'll be so much more productive as a result. The one I bought was made by Laniakea and was inexpensive. 4 Things You Need to Know The diameter of the hole is 1/8". Even though the fit is a little tight, it will be perfect for your needs. I'd like to congratulate you on the final result. These powerful lights give off an elegant and natural appearance. The light is 3000k and very bright. The color should not be too blue. Personally, I dislike the colour temperatures that are higher in the daylight. Buying without hesitation is a wise decision. I am amazed by them.

Derek Adams

| Aug 18, 2021