Knape & Vogt 256P-ZC Shelf Support, Pack of 12
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
To fit it into the slots, it needs to be pushed upward and downward
As the first letter of Knape and Vogt, KV represents Knape and Vogt. The Vogts Support for the Vogt) shelf.
I purchased this set of stainless steel shelves for shelves that are 1/2 " from the top of one hole to the top of the next hole. These clips have a width of 3/4", so they can be pinched 1/4" and fit snugly. As far as I know, the "NUBS" on the clips that fit into the holes are 3/16" of an inch wide. I do not own the safe in question, however if the above measurements match, it should fit.
There is no way I can know for certain. The shelves were used for built-in shelving under a radiator vent in a 1948 building, but it had been more than I think the shape is right, but they could be too big, so see if you can find good dimensions and look at what the slots in the cabinet look like.
Selected User Reviews For Knape & Vogt 256P-ZC Shelf Support, Pack of 12
The brackets just were not there. I thought it was the end of our wedded bliss, but upon closer examination I found it was nothing more than a snag. As a result of my marriage being saved, I now have a sense of purpose. There are two parts a bracket and a shelf support. It can do everything, so why can't it?.
The first time I tried them on, I thought they would not To hold it together each time you place one in the track, I had to use pliers. You almost feel like it's open too much. In that case, I hope you understand. This keeps it in the track, however.
In the 1980s, I used to work as a cabinetmaker at There was only a small amount of V hardware available. Recently, I bought a gun safe that came with some malformed Chinese shelf clips that fell out and caused the shelf to fall inside 12 hours after installation. In the end I went back to what I knew and ordered a bag of There are a number of V clips available. It's true that has changed a lot since it was first introduced. The materials used to make them are thin and far from the quality I was used to. Nonetheless, they do the job, they do not fall out, and they don't cause any problems.
I'm so sorry! This is going to be a blast! It is a simple, effective clip that fits into slots on certain shelving units and does a great job of keeping those shelves from falling down onto the floor and spilling your books, laser disks, or commemorative cat plates onto the ground. The security here is enough to fill three shelves. The number of things that aren't falling is astounding.
There is no better clip to purchase than these. It is terrible that it is made in China. What are the main differences? This is the K&M There is flex in the body of the V. To insert the bottom tab into the slot, you place the top tab in the slot, press a bit to compress the clip, Once it is secured by the tension, it snaps in. It's impossible to get a 'just right' fit with the cheaper versions that require pliers.
In all honesty, the vertical brackets, the parts that attach to the wall, are thin and spindly, and I am reluctant to press them into place until the verticals are mounted in order to avoid bending them. I am sure that they are hard to fit in. As soon as my handiman shows up, I will hand over the project to him, but I was planning.
There are very few differences between the originals and these While they are a bit more difficult to install, they are more secure and don't move around as.
They filled in nicely for the shelf supports that were missing. shipping was fast and the price was reasonable. I drove to the hardware store for a lot less than I would have paid for gas.