Brybelly 6 Deck Automatic Card Shuffler - Battery-Operated Electric Shuffler - Great for Home & Tournament Use for Classic Poker & Trading Card Games

Three different things are done with this A deck hand is responsible for maintaining the deck The game of Canasta is played on the feet. My thumbs are affected by arthritis, so it is difficult to shuffle by hand. I play with my wife several times a week and it works just fine. Our secret will become clear once we learn it. I had to shuffle dozens of times with the same three decks before cards were feeding well, and it got progressively worse as I went on. When I set the decks aside to look at the shuffler, I noticed that there was a slight curve to the cards. We initially thought it was the feed wheels. A slight bowing was noticed because the cards were being shuffled so often, but this wasn't enough to stop them from feeding. As a matter of hunch, we flipped over the deck (so that the faces rather than the backs faced up in the shuffler) and it immediately went back to working. In the end, it was the cards, not the shuffler, that caused the problem. The deck may have to be flipped if your shuffler is performing slow.

Pedro Holmes

| Dec 27, 2020

I use my shuffler about 14 hours a There were no problems at all. As with any other low-paying job, it has its pros and cons Nevertheless, it is a relatively expensive mechanical item. You should be able to use it for quite a while if you are careful with it. I saw several negative reviews, but if the user had looked a little closer in the Amazon item page there is a link to a page that shows you how to fix almost anything. To get one that will last more than 10 years without any problems, you'll have to spend A LOT more than you think.

Cesar Waller

| Sep 22, 2020

My mother-in-law is getting this for the second time I have purchased it a legal document. Her shuffler is used often for playing canasta and she uses it several times a week. A rubber wheel that moves the cards into the shuffler wore out on the last one. The construction is made of thin plastic and needs to be handled with care. Specifically, she says that she has trouble pressing the spring lever used to start the shuffling. According to a close inspection of the lever, it is made of flexible plastic, allowing for the lever to be pressed down to operate As time goes on, this may get easier, and at some point it will My money would go to a shuffler if it proved to be more reliable and was less expensive than what I had been paying.

Donovan Marks

| May 27, 2021

Playing Hand and Foot is an activity I bought for a group of friends who are playing. In terms of function, everything worked ok, but since at the end of the game the card numbers are grouped together, rearranging them takes a lot of effort. The system worked for a few months, but now only one side is functional. When I took it apart, one of the wires had been poorly soldered, and one of the connectors must have jiggled loose more than once. There is no point in returning it, so I am out the cost.

Update. Soldering is something that my friend does well. Wire was soldered today for me by him, and we used it today. I have found a solution and it Yes, that's right. Batteries must be taken out as well as two long screws that are recessed into both holes of the When you have access to the wires, you can pull the two sections apart. It's an easy fix if you know how to solder or if you have an acquaintance who can.

Brylee Bruce

| Jan 25, 2021

Some games contain over a dozen decks of cards! I found it did an okay job of shuffling when it was brand new and the batteries were fresh . . . though not completely If you run a few tests using the same amount of cards on both sides, one side will finish before the other, and you will have to split that pile down into two smaller piles to continue. Battery capacity reaches half charge or less, at which point the device becomes unusable. Although the activation button is fiddly and sometimes difficult to engage, I have read there is a manual repair (if you are okay disassembling the device to fix it), but I have yet to encounter it in practice. This is also true for Because of how much usage I put this through, I will be replacing it with a more reliable model. Battery power largely affects performance, which is why it should also be plugged into a wall outlet. I believe this is an overall fail for someone who does a lot of gaming with cards, but if you're a casual user, you might be fine with how this works. I am not even willing to give it away at this point. As long as it occupies space at the closest landfill, there will be no harm done.

Zaniyah SHARPE

| May 28, 2021

The price of this item is good at the time of writing. While I was pregnant with my child, everyone in the house got bored and took up card games to pass the time. I got bored of shuffling between turns at UNO and bought the shuffler at the time. I have used this shuffler for quite some time and it seems to work Using it is very easy, just split the deck evenly on each side and press the button to shuffle. It is very quick to shuffle and takes very little time. A set of 4C batteries is required to run this shuffler. Although this application was easy to use at first, after a while I grew tired of having to press down the button to shuffle the cards in the middle of the game The UNO is on the right. I was inconvenienced by this minor inconvenience, so I had to tinker with the shuffler, which led me to discover how easily this shuffler can be repaired. In order to mount the new toggle switch, I replaced the old momentary push button with a 4mm DPDT mini toggle on/off switch and drilled a 4mm hole. As a result of the new toggle switch, I can do away with my fingers holding down a button for a long time until the deck is shuffled, rather than having to flip the switch to turn it on. A minor inconvenience made me mess with this shuffler even more was that it is battery operated, and so I had to use 4C batteries to run it. My previous shuffler relied exclusively on a power supply, so I decided to upgrade it so that it would be powered by both battery and power supply. For the 6V 2A 5V AC DC power supply, I came up with the following solution. Divide 5 x 2 by 5 to get the answer. An AC power adapter and a 5 mm power cable are included. Divide 5 x 2 by 5 to get the answer. I mounted a 5 mm female power jack panel mount connector on the back of the shuffler and used the default wiring for the connection between the positive terminal of the connector and the positive terminal on one motor, and between the negative terminal of the connector and Two diodes have also been added to the default wiring in order Despite the time constraints, I enjoyed working on this shuffler immensely. Unless there is something seriously wrong with the gear box, all parts, excluding the gear box, are serviceable, at least to me (I don't do gears), and anything that breaks is easily repaired. would like to upload photos for this review, but I am unable to upload them at this time as the listing appears to be denying all uploads.

Dalary Martinez

| Apr 11, 2021