PaintballSky Paintball 34" Fill Whip Hose Extension - 4500PSI Same as Ninja Brand
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
It's a braided hose made of stainless steel.
I'm not sure, but I use it to fill my high-pressure air tanks for paintball guns, so it should work if your air bow uses the same tanks.
It's 1/8 npt, I believe.
Selected User Reviews For PaintballSky Paintball 34" Fill Whip Hose Extension - 4500PSI Same as Ninja Brand
Leaks with a pressure of more than 1000 psi. UNSAFE. When I use this supposedly 4500 psi rated hose above 1000 psi, it leaks from behind the crimped fitting on one end (not the threads). The hose is literally bursting at the seams. This device is a piece of garbage, and it's also dangerous. br>br>On top of that, instead of the 1/8" female to female, then male to QD fitting shown, there was only an 1/8" female to QD fitting. I bought this hose specifically because it came with the fitting I needed. Updating your photos to reflect what you're actually selling is a good idea!.
I purchased this for my Benjamin Discovery air rifle, and it is an excellent product. I also purchased a TKO muzzle break to go with it. This cool mod is most likely familiar to the air rife community. Well, I was having trouble filling my air gun with a hand pump that I bought on Amazon. The pump is great for the price (under $150), but every time I refilled the gun, I had to take out the TKO muzzle break! This appears to be a fairly uncommon issue. I tried a variety of techniques to increase the size of my barrel, but none of them worked. My issue turned out to be that the female quick connect piece was far too thick to fit beneath my TKO muzzle break. This long hose had a low-profile female connector and worked perfectly. There's no need to remove the muzzle break any longer! Aside from that, it's a must-have item of high quality.
The hose that came with the scuba yoke adaptor for my marauder was extended using this whip. The one on the yoke worked fine, but it was a little short; now that it's longer, I can keep my tank on my gun and shoot it at the firing range without any problems. With this setup, I can shoot for a long time without having to stop every few rounds to refill. My tank has a 3000 psi pressure, and my gun has a 3000 to 1500 psi pressure range. I just keep my gun tethered to my tank and don't have to worry about constantly checking my gun's air pressure while shooting.
Now I can just hook up the pump and go, leaving my rifle on the table. When I finally get my scuba tank repaired, I'll be able to extend the connection. hydro'd. br>br>In short, it's very handy to have; the price is a little high for such a basic item, but I couldn't find anything cheaper.
There isn't much to say about a house other than that it was reasonably priced and delivered promptly. It is, without a doubt, of high quality, and it was much needed. Thank you for your prompt and courteous assistance.
This is a high-quality, fully braided product. It's the ideal size for my PCP air rifle.
It's incredibly simple to refill tanks with this system. It's so convenient.
Perfect for extending the length of the Benjamin PCP hand pump or any other hand pump. Connects to the existing short pump hose and adds enough length to allow you to leave your air gun on a table or bench rather than laying it on the ground or on the floor. Due to the extra length, only a few more pumps are required.