AAE Max Stealth Vane Flo Green 100 pk.

This is a 7-inch long box

In the beginning, you will apply the AAE primer pen to the foot of the vanes, and it will need about 10 seconds to dry before you apply the max bond glue. This is necessary for the glue to set since these are made from a material that does not allow it to (It surprises me that people complain about having to do this all the time in addition to having to use the AAE whips. It takes about 10 seconds extra, and both products cost less than $15 together and will do hundreds of blades. There is also the option of purchasing hybrid vanes, which are similar, but they are made of a different material. But Second, acetone should not be used. The AAE whipes are very similar chemically to regular acetone, but regular acetone has an additive that leaves marks on the shaft when it is applied to it. It is the following steps that I take that cause my vanes to stick so well to my arrows (both aluminum and carbon since I do not use vanes wrapped in tape). Please note Br>- AAE Max wipes can be used on arrow shafts (then put the wipe back in the pack and reseal, the arrow shafts will last for years) Using the AAE MAX primer pen, apply primer to the base of one vane and allow it to dry under good lighting. Note you can watch the primer dry in a few seconds under good lighting (Tip Saturate the tip of the pen with the primer solution with the tip depressed) - Apply a bead of AAE MAX bond to the base of the vane and adhere it to the shaft once the primer has dried. Keeping your fingers firmly pressed for 10 seconds This will take a few Please note Br>- To remove excess glue, wipe it off with a damp cloth. To the front and back ends of the vane, apply a drop of MAX BOND. Please note Br>- Put a new coat on and let it Here's a tip Find a lot of great info about nocks on arrow fletching by searching "nock on arrow fletching".

Grain equal to 2 grains and one grain less The number of grains is five

I am 7 inches long. The height of five inches