Seaflo High Flow Blower Fan, 320 CFM 12 Volt
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
It takes (approx.) five minutes to take the taste test The ID is 1/2" and the diameter is 5 The outside diameter of the tube is 7/8".
On top of it I put 5 inches of gose. It is not possible to use a dryer vent hose outside unless it is 4 inches long
If you have a 12 volt vehicle battery, this can be connected directly.
In Washington state, it runs between 32 and 100 degrees fine regardless of the temperature, such as when cold or hot. *Note I run 2 fans and operate 1 port and
Selected User Reviews For Seaflo High Flow Blower Fan, 320 CFM 12 Volt
Besides the price and the concept of "flex mount", I was drawn to this blower. I was disappointed in a few areas, but I managed to get the system installed to some degree, just not in the way
The first warning was the fact that the wires coming out of the motor are There is nothing special about the copper they tinned on the ends. Right away, you can see this item does not qualify as "marine grade". First I unplugged the wiring and changed it out with marine wire. Next, I discovered that the "flex mount" was As you can see in the picture, the mount for the fan is the only way to attach it. In my opinion, the mounting foot should be able to switch to a different housing screw to adjust the position, but that isn't the case. Last but not least, the tubing size is the same as the output. If you want the blower exhaust hose to slide into the opening, you'll need an adapter to connect the two or you can loosen the screws holding the housing together. The housing won't completely close back down on the hose as a result of this. A worm gear clamp was installed around the housing to make it possible for it to be safely tightened again. My attempts to seal the plastic were abandoned when the plastic refused to cooperate and I couldn't get a perfect seal, but I got close. I have good news to share with you There is a good amount of air movement and the blower is whisper quiet. Like most Seaflo products, this one has a low price point for a reason. They have a warranty for a couple of years, but who knows if they will follow through on it.
This would be an excellent product for people who like to spend a weekend on the water. Boats used in commercial or heavy saltwater operations are less likely to be affected. In addition, these units do not have ignition-protected blowers, so they cannot be used with gas engines! A message from Mike at.
In the exhaust system I designed, I used one of these blowers and it was a great purchase. Then, I purchased another one and found the blower cage to have been out of round, so it vibrated really badly. The third one is on its way after I send it back. The 2nd one was also about the same. I think it was slightly After the third, I held on to the fourth and got a fifth one instead. With the fourth machine, apart from vibrating, there was a clacking sound coming from the motor as well. Due to the fact that this blower was already integrated into my design, I reluctantly kept the third and sent back the fourth. It appears that this supplier does not conduct any incoming or outgoing testing or inspections, so the quality of their product is poor.
". It takes imagination to use a boat fan to expel engine fuel fumes. I surfed through a hundred portable fans on Amazon, but this was the best one I found. 320 cubic feet of air are pushed each It's time to turn the testosterone machometer red! Using a motorcycle battery and a switch for a light, I connected it. So I do not have to disconnect the battery for charging, the bolts are connected to the battery ( with wires). The purpose of ropes and hoses is to carry. In the near future, I will replace switch with variable resistor. At 1 hour, I was running with no issues. I'm not sure how long the run has been, but so far it's been fine. Snicker not, there were no blueprints.
Squeaking and rattling sound. Initially, it was nice and silent, but after two weeks, it started making a Squeaking and Rattling noise. I don't use it 24/7, but after two weeks, I can hear it squeaking and rattling. I think a cheap $22 box fan from home depot, which I got at home depot, would be a better choice. Please be aware of GK Wholesale. They did not reply to my e-mail until I filed a claim and they did not provide a return label for a defective item.
After running the fan for roughly 200 hours with a large carbon air filter in the intake, I've been able to prevent the issue. As a result of adding the carbon filter, its noise level has increased, so I made a box around The Mac Pro is a great laptop - plenty of power for its size This air intake would be ideal for my application of purified air. Thanks for your kind words!.
A SeaFlo SFIB1-L was also purchased From 270 to The best option for my application was 02, which worked better for me. Even with this being a noisy unit, it put out more air than an equivalent 320CFM model when you use old-fashioned hand-over-snorkel.
has so many amazing features that it doesn't use a lot of power and allows it to do what it was designed to do.
We replaced another brand of blower with the same flange size. This blower consumes 5 amps when it is running, about 7 amps when it is I prefer it over the old one because it moves more air and is quieter. When my old port blower fails, I will replace it with one of these.