Arrow Shed AK4 Earth Anchor Kit
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
One inch is how big it is. This cable may look small, but it is one eighth inch thick. With 1 inch of space for fitting a crow bar into the ground, there was enough space to screw the bar in.
A galvanizing process seems to have been applied to the cables. A year later, it is still shining
It might not be necessary for you to use your anchor if you install a flooring and depending on how much stuff you intend to put on the floor. I haven't used my anchor yet.
It is not obvious to me why this should be the case
Selected User Reviews For Arrow Shed AK4 Earth Anchor Kit
Earlier this year, I had bought a shed and this product had been suggested to me. According to my estimation, the shed is probably 5 meters by 8 meters. However, I am confident that the anchors will hold their ground despite not having been tested I am also confident that the shed will probably blow away due to its relatively flimsy construction.
Arrow metal shed kits after they were highly recommended a few months prior to protect it from damage when there was a strong wind. In addition, they must be driven into the ground close to the shed wall, so you don't have much control over the installation. My experience was not the same as other people's, as the auger bit is supposed to drive itself into the ground. In any case, the composition of the soil clearly plays a large part in the auger's performance, but when I drove it across our lawn into what was once good farmland dirt, the auger apparently Using an auger, I dug a fencepost hole and filled it with dirt and packed it with sand to finish my installation. I used a fencepost hole digger to dig the hole, then set the auger at the proper depth and filled In a few days, the directs were packed tight enough to hold well, and so far, everything has worked out.
But they work as they are supposed to. There is a part of my backyard where high winds tend to hit my shed. Keeping it from taking flight helps keep it from flying away. The only problem is that I live in an area with a lot of clay, and it was very difficult to get these things to stick. During rotation of one auger, I bent it because I had to push down so hard. The first piece of soil they bit into went in just fine. It took about an hour to do the whole thing. The last five feet were taken before they finally succumbed. After pressing so hard on the hooks, some paint chipped off, and though they are rusty, they have already started to show clear signs of corrosive action. It might be a good idea to wrap my metal bar I used for down pressure in a towel or something to prevent this from happening next time.
Adding screws to loose soil that's recently been dug up wouldn't even penetrate through it, so they spin in place without going into the ground. I think if you were prepared to drill out a 2' hole for each screw, you would probably be fine, but you then have to wonder how much of an anchor that soil will provide once the screw is installed.
I had about six. I had a six-inch layer of loaded gravel to get through so no matter what I tried, these anchors would not bite and I had no choice but to use bullet anchors instead since I did not feel that I could return them after opening and twisting I gave them a low rating because I felt that there wasn't enough information provided about what conditions they should be suited to. Now they're stuck with me.
This Arrow shed made it through Irma and Matthew, beach side by Daytona Beach, still standing after all these years. Many of my attributes are attributed to placing a low shed under a 6-foot boundary fence and other.
For each hole, we recommend you use a post hole digger, followed by backfilling with dirt, stones, gravel, etc. to hold the anchors The ground will be covered in dirt or sand, so you won't need to do anything else to it, but you will need a pipe or bar.
Even though it is a hassle to drive them, the job is done.
Related Products For Arrow Shed AK4 Earth Anchor Kit
