Mingle Pressure Washer Adapter Set, Quick Connect Gun to Wand, M22 14mm to 1/4 Inch
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
I just wanted to let you know that In the case of Sun Joe, the fitting between gun and wand is 14mm thick. There is a 15mm fitting between the gun and hose as well as between hose and pump.
The wire went bad after a couple of months, but it never rusted for me
As long as all connections are functioning, it should be fine. A quarter inch
With this adapter, you can connect a pressure washer gun to a Wand with a We have a pressure washer wand with an M22 fitting, but the end connects to the pressure washer is not. Greenworks pressure washer gun to hose or hose to pump please purchase below product. *br>Mingle Ultimate Pressure Washer Adapter Set, Quick Disconnect Kit, M22 Swivel to 3/8" Quick Connect, 3/4" to Quick Release, 8-Pack You're Packing
Selected User Reviews For Mingle Pressure Washer Adapter Set, Quick Connect Gun to Wand, M22 14mm to 1/4 Inch
With my SIMPSON MegaShot 3200, I take pictures with the following settings In PSI 2, we look at the following It still has a hot water gas pressure washer with a Honda engine, but I would like to upgrade to quick connects since I often had to remove Two of these were bought to be placed on each end of the hose, one for the wand and the other for There were no problems installing the system and right out of the box, there have been.
The two sets I got are both the same set. I found them to be very useful. Fast connection and disconnection of the pressure house is no problem for me. The result is fantastic. Using the hose does not require me to keep the washer connected. I am so grateful for it now as it makes using and storing our washer so much easier. In terms of winding up the hose on the washer, Generac did not provide a good solution. As a result, I now keep the hose separate from the washer when I am not actually using it.
They came with RYOBI 2000 psi washing machines. The foam cannon was attached closer to the water pressure hand gun instead of at the end of the wand, and the quick connection was used when switching to high pressure nozzles. The product's quality has remained constant after several times of use. I have not observed any water leaks at any connection points. I would highly recommend this product!.
Unfortunately, quality control is not as strict as it should be. It appears I only received a male fitting on my order, so I had to contact Amazon for a Both halves of the replacement and works were provided.
In addition, it is completely reliable. My foam cannon used to be on the end of the wand, and I had difficulty controlling it. I find it much easier to use it since it is so close to me.
Despite the fact that there is a tiny bit of play in the connection because of the weight of the wand, I do not think anything could have been done better. There may be an issue with the gun to which it is attached if that happens.
My pressure washer's discharge side is connected using these fittings in order to facilitate a quick connect-disconnect process. Using a 1/4" snap fitting on the pressure hose worked well for me. You won't have to struggle with putting the hose on the pump and there'll be no leaking.
The Ryobi 1600 PSI can be handled well with this pressure washer.