New Printhead Print Head for Zebra GX420D GK420D ZP450 ZP550 ZP505 ZP500 Printer 203dpi PN 105934-037
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
The printhead you will receive is a genuine Zebra GX420D/GK420D printhead.
Founded in 1987, we are a full-service fulfillment Three weeks ago, I used a new print head on two of the main label printers. Their labels have so far totaled over 4k in each print. A combination of 90 percent alcohol and daily cleaning after each label roll will yield the best results.
There is no problem with the printhead. This is the genuine printhead for Zebra GK420D and GX420D printers.
Selected User Reviews For New Printhead Print Head for Zebra GX420D GK420D ZP450 ZP550 ZP505 ZP500 Printer 203dpi PN 105934-037
I obtained the item, but it did not appear to be the same as the genuine Zebra OEM print head from the GK420D In the beginning it worked well, and for a few days, I had fairly good results. After about a week, however, it started printing so dark that the labels started to have a heat bleed to them and the barcodes could not be read by any of our It has to be said, though, that I did have to reinsert the old print head that printed with lines missing, because AT LEAST SOME of our labels could be scanned with the In the end, this "Genuine" part was of no use to us, so I replaced it with a REAL OEM print head obtained from an official Zebra reseller, and returned it.
You might want to avoid this installation if you are afraid of heights It is possible for you to succeed if you are bold! Open the mouth of the printer while it is on its back. The little plastic lever by one side of the part looks like this. Find that piece. Pop it open. Now that the print head is loose, it will print better. It might feel hard to get it out, so pay attention to how it feels as you wiggle it out. Replace the two tiny strips with the new unit as soon as the two tiny connections are disconnected. If they are stuck, you will need to use a thumbnail or probe to remove them. You need to choose which side to put up carefully. Please be sure that both sides have been slid in fully. Place the head back in until you hear a click. Check to see if it feels like it is on springs by pressing down on it.
Our label printer was exactly what we needed to replace it. This printer was easy to install and, once adjusted, produced excellent prints.
It is slightly darker than my old print head, but I bought the printer used, so it is not a big deal In fact, this one should last longer than the one I had before because the one I had before was used and the one I am reviewing now is brand new. If I have any issues in the future, I will update the.
There was a problem where one area of the label always came out blank and I had to clean the print head indefinitely Well, no more of that. I literally found the solution to all my problems here. Now that life is good again, everything is okay.
As far as we can tell, the product is in Neither of my thermal printers ZP505 or ZP450 were compatible with this driver.
There was a discrepancy between the picture of the item and the product listing. I was able to use it for an emergency but it does not hold securely within my Zebra ZP450 The good news is that it arrived in.
THANK YOU FOR YOUR EXCELLENT REPLACEMENT. It can be installed within minutes, all I need is a screwdriver (I have an eyeglass one handy), I have another printer and will buy another for backup.