Weewooday 6 Pieces W1209 Temperature Controller Board with Case 12V DC Micro Digital Thermostat -50-110 Degrees Celsius Electronic Temp Control Module Switch with Waterproof NTC Probe

Weewooday 6 Pieces W1209 Temperature Controller Board with Case 12V DC Micro Digital Thermostat -50-110 Degrees Celsius Electronic Temp Control Module Switch with Waterproof NTC Probe

$ 18.99

Score By Feature

Based on 33 ratings

Temperature Control

9.68

Accuracy

9.48

OveReview Final Score

How Our Score Is Calculated

Product Description

It can be used to regulate temperature, and it has features such as complete machine patching, wave soldering, stable performance, and low power consumption The embedded CPU chip is more intelligent, it consumes less energy

Waterproof NTC probe the NTC probe controls temperature to control heating or cooling. Please note that the wood laminate case is the clear plastic case, which is thin on the outside, protecting the wood inside from scratches. And you have to assemble and install the case by yourself.

The embedded CPU chip and MCU offer high performance, lower power consumption and automatic power setting of the memory. The MCU has an internal EEPROM storage unit, offering an ultra-low power consumption.

The accuracy of the control is zero, making it reliable to use. The devices have been tested for consistency, stability, and reliability for temperatures of up to 1 degrees Celsius

Press + or - to get to next Parameter, press set to select it, press + or - to enter the value, press set to accept it, long press + or - = reset to default, power out resets to default, default temperature is set at 34°F. The following table shows the temperature in

Questions & Answers

Is it possible to use a single thermostat to control both the heat and the cool temperatures, or do you need two thermostats to control the same You have 2 temperature ranges to choose from Does it work?

Since they can only operate in one mode at a time, you would need two of them to control both heat and cooling. Furthermore, there is just one relay, so there is only one way to control the device.

Could I use this to turn on a 12 volt fan once the outside temperature reaches 22 degrees celsius or higher?

In short, yes. You'll be fine provided that the fan amps don't exceed what's comfortable.

What about a model that runs on 24V?

To not power on and off the unit so it can be activated and deactivated. Chips will be fried when they are fried. Despite this, the switch itself can withstand very high voltages).

How do you display the temperature of the unit being monitored?

In short, yes.

Selected User Reviews For Weewooday 6 Pieces W1209 Temperature Controller Board with Case 12V DC Micro Digital Thermostat -50-110 Degrees Celsius Electronic Temp Control Module Switch with Waterproof NTC Probe

This is a nice W1209 temperature controller board with a case

5/5

2/28/2021]
I've been using them for heating This is excellent.
[Original 9/29/2020]
I was looking into a simple system to protect plants over the winter season. I don't need this many batteries these days, but it's nice to have backups.

Putting together the case took me about a 10 minute process to peel off the covers and fiddle My coffee has already gone cold due to the heat. Although, it's just one time and the case is actually pretty nice.

I then did some quick tests for some of the basic functionalities. By the way, they are not easy to find thanks to google, but with enough research you should be able to locate it. With P0 set to "H" (heating), at 27C with offset (P1) set to 1C, I decided to use that. Those will be accounted for at 2) and As such, you must view the set temperature as a target temperature where the device ("heater", in this case) must not operate. So it works, but it was a little different from what I expected and what I saw in some of those "documents". As such, it would be very helpful if the seller provided a doc which describes how the product actually A second observation I made was the fact that I was expecting the relays to be rated at 20A at 125V from the product photos. This is actually 10A, which is not a practical problem since I don't know of any need for that high amount of I just want to bring it to your attention. This is, overall, an excellent value, and I look forward to making some greenhouse plants more comfortable this winter.

Keilani Kline

| Dec 05, 2020

The following precaution is in effect It's a great product

3/5

Luckily, the very first unit that I assembled worked. As soon as I turned on the indicator light, it went out! My research revealed that the off circuitry relies on an indicator LED in order to be a logical input to the gate that is responsible for turning Therefore, if your LED does not work, make sure your equipment continues to run, regardless of whether you preferred it to be turned There may be a way to shunt the LED by using a high-voltage cable A value resistor will supply the logical '1' after the LED is burned Aside from that, DO NOT use this product for anything that might lead to adverse effects if not carefully Now that I have saved you from untold expense, let me tell you what an awesome, fantastic, easy, and intuitive bargain this product truly A small oven for curing resin and sterilizing masks was made with just a few parts. It works perfectly well with the light source (a 75 watt drop light coupled with an old set of aluminum pans clad with polystyrene foam). As long as the operation is supervised, it is perfectly safe.

Alia Lara

| Dec 31, 2020

I've never seen anything like this! The other is used as a safety backup on a system that relies on Alexa to control hot water recirculation

5/5

The pump actually starts and stops on time according to Alexa, and the backup cuts power to the pump in case she becomes irrational. They are so cheap that I could not even afford to buy a relay for the price! And, they are Can you explain why I need six? There's no way I could say. It's too early.

Alexis Lopez

| Nov 06, 2020

This controller is perfect for solar-powered exhaust fans powered by 12V

5/5

Simple to install and easy to use, this unit is small and convenient. This item comes with a clear plastic box you can put it in or not, up to you. In addition to being accurate, it could easily be programmed to turn on and off when you want. With this, I can control the intensity of my greenhouse exhaust fan 12 volt solar power by Some people don't like having it set in Celsius since that is the only drawback.

Fallon Good

| Oct 20, 2020

This is a diy nerd's dream! Can you tell me what I can do? The material is warm, easy to read and the thickness is just right

5/5

My assumption about what that has to do with the sensors is a complete mystery to me. With them, I monitor and control the temperature of my Dayton bass shaker box, which I use as part of my racing simulation setup. Connected to computer vent fans, they provide a great deal of airflow.

Anna Robles

| May 10, 2021

It worked just like it said

5/5

While earlier models had a little larger case, I like the way it saves space. Being waterproof during outdoors temperatures and other tests is also a plus. The assembly is easy. This is a nice-looking device with blue LED readout. A simple set-up and easy adjustment process.