LEFOO LF20 Extended Duty Pressure Switch 10psi±2psi Adjustable High Pressure Switch Oil Pressure Switch Vacuum Pressure Switch
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
Because there is no difference, I would say the contact would open at 9 a.m. in your example. 9 psi. When the pressure rises above the set point, it reacts almost immediately.
1/8" - 27 NPT - Most oil pressure sensors and switches are built to the same specifications.
According to the Lefoo website, the pressure for is 150 psi. Pressures range from 5 to 150 pounds per square inch. Switches with a pressure range of 25 to 250 psi should be rated at 250 psi.
Hello Richard, There are three terminals on the swith: NO- As a result, it can either be open or closed normally. Depending on how you connect it, you can change the way it works. I hope you find this information helpful. Thanks
Selected User Reviews For LEFOO LF20 Extended Duty Pressure Switch 10psi±2psi Adjustable High Pressure Switch Oil Pressure Switch Vacuum Pressure Switch
This switch is extremely versatile, as it has both normally open and normally closed contacts. It took me a long time to figure out that the only way to adjust it is to pry off the top rubber plug. There's a bolt underneath it that requires an Allan wrench to remove. It appears to have a wide range of adjustment, but I'll have to play around with it to see where the limits are. I'm already planning on placing a second order. br>br>Recent changes: br>br> With these pressure switches, I was able to make a very accurate water tank level gauge! Each LED light on the gauge has its own switch. Each of the lights is a tenth of the volume in my tank and is displayed vertically. I assigned a pressure to each pressure switch based on the pressure of the level it represents. I can tell how much water is in my tank just by looking at it from a long distance. When the water is turned on, the level drops a few notches, allowing me to detect leaks with this gauge. When the pump is running, I have a second led on top that blinks. The blinking is caused by minor pressure fluctuations in the pump's filling pipe, which the sensitive pressure switch detects. The tank and the gauge are not connected by wires. A small solar panel powers it. No more leaning on my water tank with a ladder! I drilled and tapped 10 1/8" pipe holes in a piece of pvc pipe. The switches were inserted into the holes with screws. It can be placed anywhere along the pipeline, but it must be calibrated for the specific location.
from exceeding 10 psi (/-) with a powered pump and a small air tank (approximately 2 pounds per square inch). This was sufficient. I've managed to get almost all of the leaks out of the system, but not quite all of them. The air pump "burps" every 30 minutes or so, and the pressure returns to normal. It was very simple to install and wire, but I also have the necessary tools to properly place connectors on wires and so on.
It's perfect for a turbo vehicle's booster-activated switch. Allen wrench is used to adjust the height. I've experimented with pressures as low as 5 psi and as high as 20 psi, but I believe it can go even higher.
"C" "NO" and "NC" are the three pins that work well together. By prying off the rubber cap on top and adjusting the screw with a 5 Allen key, the switching pressure can be adjusted. Mine can go from 30 pounds per square inch to less than 5 pounds per square inch. I had to buy an adapter to convert the switch's pipe connection from 1/8" NPT male to 1/4" NPT female. Thank you for your help.
It does the job well and does not leak. On zero turn, it's used as a low oil pressure alert. You have the option of using NC or NO contacts.
Related Products For LEFOO LF20 Extended Duty Pressure Switch 10psi±2psi Adjustable High Pressure Switch Oil Pressure Switch Vacuum Pressure Switch
