14 Gauge Jumper Wires Alligator Clips to Alligator Clip Heavy Duty Silicone Test Leads Set 2Pcs 39"/1m

The ones I used to have were decent ones that I believe I bought from Home Depot, but they wore out faster than I anticipated, so I decided to buy There was no response from the manufacturer, and I was There is a struggle to open these all around, they don't open wide enough, and they don't hold up.

Jacqueline Gorman

| Sep 20, 2020

I consider them to be stale chips and aren't of much quality. A home user can use them to get the job done, but they are not suitable for professional use.

Dani Rogers

| Aug 31, 2020

The 14 guage silicone wire is flexible and made from silicone, so it is flexible. We had a 16 hour power outage, so I grabbed them to see if I could break them! I don't believe that they did! It took me four hours to balance charge my (4) 12 Volt 130 Ah A 25-amp continuous power supply can be run in a 75-degree garage for two hours. I have no problem with that! It is only when the wires are touched that they become warm. After that, I said to myself, "I'll make these fail! I'm going to make them fail! I connected the jumper wires to my 275 foot deep Well Pump, connected the end wires from my 240 V 5000 watt generator and switched it on. My generator groaned and struggled to start that pump from that deep well. I QUIT MY JOB AND FINDED ANOTHER CALL! Even after taking a hot shower and filling two 30 gallon barrels with water, the wires are still cold. I am stunned. These are going to be my next purchase.

Violette Wright

| May 01, 2021

There is excessive force required to open the clips and can't be opened enough so that a 1/4" bolt can be attached. The wire is cheap as well. A listing implies that the quality of the product is much higher. Amazon returns are rarely used by me, but this time I took advantage of the service.

Nixon Conley

| Jan 03, 2021

Test leads with high current are needed to clip onto the laser diode pins in order to test a 10 to 15 amp laser diode. Using these leads is a very efficient way to test high current components because the jaw springs are strong enough to grasp the components and they aren't too small or You will be able to open the clip jaws It is enough to test components with a size of 2". The leads were cut in half in order to make them easy to connect to my lab power supply, and the diameter of the wire was measured at 1mm, so I cut and rew them. This is consistent with 14 gauge stranded wire of 8 mm in diameter.

Thatcher Schwartz

| May 17, 2021

It worked perfectly for cranking over my motorcycle with plugs removed and grounding the plugs after the coil failed to start the motorcycle. However, I had to ground the plugs out to ensure they wouldn't be damaged when the motorcycle failed to start. Despite how tight its is to open up the jaws, not only are they brand new, but I also want them to latch on to the bolt/stud, whatever it is, One person said they were useless because it was hard for them to open them, and another that they could not be used to jump start a car. That is definitely not what they're designed for. Test leads are what they are designed for and they do what they are meant to do.

Colter Chan

| Aug 07, 2020

They were used for a bleeding-edge design The resistor is well made and it is a down resistor. and insulation are of high quality and can be easily stored because they are flexible.

Harleigh Fry

| Aug 17, 2020

My husband and I recently purchased a new boat, and I upgraded it several times. We used them to test and hook up different pieces of equipment without having to haul the towing vehicle around. An 12 volt battery charger was used to power the device.

Jada Love

| Aug 10, 2020