Adiyer 10 Pcs 8mm OD 20mm Length Compression Mould Die Springs for 3D Printer Ender 3 Stock Bed Leveling, Light Load

The print was stinging after I took a long print. I will eventually get an auto bed leveler, but these fixed my issues and seem to keep level ( although I sometimes still check before a print) These springs have more tension and look the same as I had on my previous bed but they keep everything level for longer periods of time.

Neil BARLOW

| Oct 06, 2020

There is an Ender 3 Pro in my possession. Prior to installing these springs, I still needed to manually level my bed about every three days, even after installing a BL Touch. As a result of the installation, my bed has not needed manual adjustment It has been over a month since my printer has been running almost continuously without leveling. The upgrade I would really recommend for an Ender 3 printer here is this one.

Willow McConnell

| May 09, 2021

It used to happen that the length of the springs in my printer beds varied by about one millimeter before I ordered heavier springs for them. In all of these cases, the springs were within 0. 1. 8 of the 16 measurements are within 0. 4mm, with 4mm being longer and 4mm being shorter. The length of this string is 2mm. The fact that they were so cheap surprised me given their quality. So yes, high quality springs.

Phoenix Blackwell

| Oct 19, 2020

Since I've had my Ender 3 Pro for about three months, I've been using these. As a result, they are much stiffer than the stock springs that came with it. Due to the fact I replaced the stock springs almost immediately, I cannot speak directly to how much they have helped. There is little to no cost for them, and they appear to do a good job.

Hopefully this will be helpful to someone new to Ender 3.

Nala Schmidt

| Sep 22, 2020

When you install the stock spring, your Enter 3 will function as intended. Replacing them now will save time in the long run. These replacement springs are pretty tough, since the stock springs wore out pretty quickly. Taking a finished print out of the printer no longer causes the bed to go out of wack or cause other issues. Definitely a replacement that needs to be made!.

Liberty Kelly

| Jan 08, 2021

It is extremely easy to accidentally move the knobs on your Ender 3 while adjusting the print bed, since the stock adjustment springs in the printer are not very strong. I have found that my adjustment has become a lot more positive and reliable since using these stronger springs. My opinion is that it is one of the best upgrades you can do for your Ender 3. The one I have is special to me.

Kenzo Lester

| Jul 30, 2020

I bought these Ender 3 springs to replace an Ender 3 spring that was kinked, and the replacement was due to come in a week or so. We've been running the printer almost continuously for the past month, and they're still I only have one complaint the hoses are a bit long, so you have to take them a long way down to fit over.

Samson Carrillo

| Mar 10, 2021

A bed that requires leveling every time a print is made lacks the springs on the stock frame. I highly recommend these, they're easy to install, and you'll only have to check the level about every half dozen prints.

Amalia Rollins

| Aug 30, 2020