ReliaBot 300mm MGN15 Linear Rail Guide with MGN15C Carriage Block for DLP UV 3D Printer and CNC Machine
Score By Feature
OveReview Final Score
Questions & Answers
Hello, separate carriage blocks will be delivered to Amazon's warehouse in approximately 5 weeks.
hello, the ball is about 2 inches in diameter. 778mm
Hello, the block's threaded holes are M3x4 in size. The dimensions are 6x4 (d x h x d). 5x3. 5mm. Please see the listing's sixth photograph.
It measures 10 mm in diameter and has a 40 mm hole spacing.
Selected User Reviews For ReliaBot 300mm MGN15 Linear Rail Guide with MGN15C Carriage Block for DLP UV 3D Printer and CNC Machine
I'm sure it'll work fine bolted to an aluminum extrusion, but in my application, the rail isn't supported, so the rise in the middle is visible when measuring bed mesh. I assumed it was an error, so I pressed a straight edge against my glass bed, which was perfectly straight and smooth. When I used the same straight edge against the linear rail, the variation I discovered was identical to the mesh measurement.
These linear rails have been updated in my 3D printer. It was neat and smooth when it arrived. br>At first, two of them were not flush or completely linear against the extrusion, but once mounted, they flattened out. br>I did purchase some "Super Lube" to use after the installation was complete. These are something I would recommend.
This is my fourth linear rail that I've ordered from Amazon. They were all on the lower end of the price scale, as the other three clearly demonstrated. However, this rail, this rail, this rail, this rail, this rail, this rail, this rail, this rail, this rail, The packaging was satisfactory, the rail is extremely straight, and the block slides smoothly and without snagging. I'll clean out the block and re-grease it to make sure it's properly lubricated, but otherwise, I'm pleased with my purchase. My Hypercube Evo is also about to be ecstatic!.
WD40 was used to clean the cosmolene, and then a light machine oil was used to lubricate it. There is no discernible lash as it glides smoothly. These were used in place of the CR10 V-shaped CR10 V-shaped CR10 V-shaped CR On the Y-axis, there are rollers. Axis. I'm very pleased with the outcome.
A little too long for my 3D printer, but good product. I made a mistake, but it still worked.
They're all fine, and they're a good deal.
It's fantastic.