Andantex R3200 Anglgear Right Angle Bevel Gear Drive, Universal Mounting, Single Output Shaft, 2 Flanges, Inch, 5/8" Shaft Diameter, 1:1 Ratio, 1.21 Hp at 1750rpm
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
A 2 horse power engine should be enough, but make sure you check with the
As long as you add a second seal on the flanges, I would say yes, no problem. Oil seals (O'rings) are used when oil is to be sealed.
It has the ability to handle one. The maximum power is 5 horsepower
After running it upwards of 7200 RPM for less than a minute, I realized that it was quite noisy. There is no vibration at all The only thing I need to do is test my setup on my Smithy Super Shop The mounting I have is powered by a quill and it appears to be a Shopsmith wannabe. It is mounted to a 5/8" R-bolt An 8 collet holds the gearbox input shaft (horizontal) and the upper flange of the vertical shaft, which is stabilized by the drill press cutout in the table of the saw. While sanding wooden parts, I have used it steadily for 30 minutes to an hour with a horizontally oriented 12" sanding disk positioned on the vertical shaft @ 600 RPM per sector with light to quite firm horizontal handheld pressure downward. It's fine for the purposes I have in mind. The thing I love is this one! By using a vertically mounted sanding disk I will no longer have to try to sand these parts.
Selected User Reviews For Andantex R3200 Anglgear Right Angle Bevel Gear Drive, Universal Mounting, Single Output Shaft, 2 Flanges, Inch, 5/8" Shaft Diameter, 1:1 Ratio, 1.21 Hp at 1750rpm
This unit cost me around six months ago and was installed on a light duty machine where 90 degrees of power angle was required. To drill and align the 3 mounting holes in the steel mounting plate, I welded a 14" length of the plate As couplers, a couple of small universal joints were used, and the machine is now running for about ten hours daily. I am very satisfied with the unit.
I did what I had to do.
This product met the advertisement's claims I used it for another application, but it didn't work for the one.
This is a robust product that holds up well under pressure. The problem is solved.
This product was perfect for the project I was working on.