Zeberoxyz 2PCS 10mm to 10mm Aluminium Plum Flexible Shaft Coupling Diameter 20mm Length 25mm Connector Flexible Coupler for 3D Printer CNC Machine and Servo Stepped Motor(10x10mm)
Score By Feature
OveReview Final Score
Product Description
Selected User Reviews For Zeberoxyz 2PCS 10mm to 10mm Aluminium Plum Flexible Shaft Coupling Diameter 20mm Length 25mm Connector Flexible Coupler for 3D Printer CNC Machine and Servo Stepped Motor(10x10mm)
Please be aware An email was sent to the seller after the review below and the set was replaced. Compared with the old ones, the new ones are far more accurate (within the accuracy range. yet to install them, as I found an alternate in the meantime, but so far, they seem to be well made, and they seem to secure well to the motor shaft and threaded rods. In any case, the replacements are fine. I am rephrasing what I wrote in the original review It is not accurate at all. To connect my printer to an 8mm coupler, I ordered the 5mm coupler. A total of four were measured. On the side that should be 5mm, the inside diameter is 12 mm, while on the other, the inside diameter is There is a difference of 24 mm on what is supposed to be the 8mm side, when they are off by as much as 96 mm in dimensional accuracy. Five percent. It is best to avoid using these.
There is a problem with the straightness of the boreholes. In reality, these cause more wobble than they are supposed to In their own right, they are already off-center as they are seated within the motor shaft In the middle. After you attach the lead screw, you will see its effect even more clearly. Keeping these in mind will save you money. Disc couplers or diagram couplers should be used Buy a real spider coupler for the money if you don't want to use these.
Adding these to a 3D printer is a must-have upgrade.
It was apparent that a large difference existed. I was very happy with the fit and the ease of installation.
Easy to use and works well.