FlameTech FTEZ-15 Scorpion EZ-Cut Complete Assembly, 15

FlameTech FTEZ-15 Scorpion EZ-Cut Complete Assembly, 15" Cut Length

$ 158.23

Score By Feature

Based on 17 ratings

Packaging

8.06

Customer service

8.44

Delivery

8.59

Giftable

8.60

OveReview Final Score

How Our Score Is Calculated

Product Description

By entering your model number, you can make sure that this fits.

With a pre-programmed mechanized speed controller, consistent push or pull cutting can be achieved.

Reduces the need for grinding and rework.

Bevel cut to a 60-degree angle

Magnets that are strong enough to work on both horizontal and vertical surfaces are used.

There is no need for electricity.

Questions & Answers

Rails that go on for longer?

Rails are available in sizes of 24", 36", and 48", but they are not interconnected.

Is it devoid of any kind of core? What type of batteries is required?

It's an entirely mechanical setup. There is no need for a battery.

What is the speed that has been programmed into the system?

There isn't a speed that you can set. It is equipped with a centrifugal brake. As a result, the faster you push, the more difficult it becomes.

Is it possible to use this with a plasma torch?

No, it's not a simple oxy/fuel torch.

Selected User Reviews For FlameTech FTEZ-15 Scorpion EZ-Cut Complete Assembly, 15" Cut Length

Works that are overpriced in comparison to their value

3/5

Expect this to be far from perfect right out of the box if you're a perfectionist. The mech for speed. The fit and finish were poor, resulting in a gritty feel and stiction at light pressure/slower speeds. The rail on the sled was a little loose. The weak magnets that come with this unit are the worst part about it; they can make setup difficult, if not impossible. br>As is, the EZ cut is appealing and has promise. My mech has already been rebuilt. All bushings were replaced with abec 7 bearings, the sled was tightened, and the magnets were replaced with switchable indicator bases (this is referred to as a runaway escapement). To speed up setup, I believe the unit also requires knob adjustable X and Z axis tip rest bars. br>If FlameTech kept improving the design, it could be a lot better. I don't think it was a big seller for them, and I don't think it was worth their time. br>I like mine, but I'm a perfectionist, and getting there cost me more money and effort than it originally did. br>In my opinion, the Scorpion EZ Cut can't be expected to make consistently perfect cuts quickly and conveniently as is, but it CAN be made to do so if you have the skill.