PneumaticPlus RED EPDM Synthetic Rubber Air & Water Hose 3/4" ID x 1.15" OD with 3/4" NPT Male Fitting Connections (8 FT-Swivel Fitting)
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
The length of this section is 8 feet. The product's length will also be indicated in the listing title.
No, you'll need to connect the hose with a piece of pipe, as I did.
It is designed to fit a 3/4" NTP. So it's about 3/4" in diameter but tapered.
Selected User Reviews For PneumaticPlus RED EPDM Synthetic Rubber Air & Water Hose 3/4" ID x 1.15" OD with 3/4" NPT Male Fitting Connections (8 FT-Swivel Fitting)
No leaks on my 150psi compressed air system using a genuine Continental 300psi working pressure hose, 8' version with solid brass swivels on both ends. I piped my standing 60 gal 5hp compressor to the 3/4" shop header so that the line hangs straight down at both ends to reduce stress at the fittings, leaves a nice loop that is off the floor, but allows for flexibility if I need to move the compressor around for servicing.
in an air compressor hose As a lead, it's fantastic. My air compressor has a hose in it. I wanted to keep everything 3/4" until the hose, and this allowed me to do so. Other hoses would have immediately reduced me to 3/8" when I exited the compressor.
I used this to connect my air compressor to a water separator that was already installed. It makes no sense to run 3/4 pipe all the way around the garage and then put a bottleneck in front of it. It appears to be well-made and durable.
These are of excellent quality and do not leak; I am grateful for purchasing them because they offer more benefits than the ones available at Harbor Freight. I'd buy it again and tell others about it.
This hose, unlike many others, does not narrow down to a much smaller size past the threads, reducing CFM significantly. It's tough, and mine is made in the United States, and it's held up well so far.
The size is perfect, and the construction is excellent. Before attaching the regulator to the wall, I just had to double-check that both connections were made. Swivels would have simplified the connections.
How are you going to connect the firings? To work around the issue, I added a pipe union on one end.
Vibration isolation up to a factor of seven. Air compressor with a capacity of 5 HP. Because both ends are fixed and do not swivel, a union will need to be installed in the piping.