Relius Solutions 1-3/4" Butcher Block Birch Top By John Boos - 72X30" - Square Edge

It is being used as a work surface on top of file cabinets. This is a flat surface. In comparison, the quality of the surface is not nearly as high as one might expect if one ordered a top-quality butcher block countertop or table from a vendor who sells Its lower cost and nature as more of a workbench, however, means that these are more effective when used for There is a likeness to the There is no difference in quality between the top and the bottom. A square edge is present. It took me one round to gently sand the top front. First one I received was damaged both on top and bottom in shipping, so it had to be returned.

The maple hardwood and the wood glue are what are in it

Where it is cut, it needs to be handled carefully. With finger joints, the front piece is connected to the back piece. It may not be visually appealing to cut through one of the joints. There could be an edge that's not visually pleasing if the surface is ripped. But I don't know for sure. The inside of the shell might also have some small voids that must There is no way to know how the ends will look if cut or how they would be finished It is almost like I am using it for utility purposes. The top of the table is meant to be used as a work surface. In my opinion, a better quality butcher block top should be used in a kitchen and should be bought from the manufacturer cut to size. Manufacturers of premium products will also offer bullnosed edges to reduce friction while using their products. You can round up the edges on the side you request, including the nose. One of the butcher block tops I have has a piece of oak running from end to end as well as no joints. If you have further questions about these products, you may wish to contact the manufacturers directly. They are of higher quality but they are also much more expensive as well.

Varnique finishes are low maintenance and are easily cleaned using a mild soap and water solution. Surfaces such as this are not appropriate for cutting. This may need to be resealed if it has been cut. Water spots and stains are also less likely to appear on surfaces finished with Varnique.