Screw Terminal Block Kit 5mm Pitch 2, 3, 4 Pole (40 pcs) by QSU
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
I found it to be more of a subjective question depending on the individual's taste, as everyone has his or her own idea of what fits. Our original design had pins that were a little thicker and a little longer in order to fit more tightly in the breadboard and reduce the likelihood of them falling out. Due to the fact that people did not prefer the thicker pin, we have changed to a thinner and shorter There are other factors to consider as well, such as pin spacing. It will come down to what you interpret the spec sheet in comparison to the spec sheet for your project. In comparing specs, you should make sure that you are comparing apples with apples. If you measure between the center of the pin and the center of the next pin on the breadboard and the terminal, do you compare two different specifications or are you comparing two different terminal sizes. Generally, a breadboard has a spacing of 2 holes per row. With our pins, we allow for a tolerance of 0.0mm and a spacing of 5mm. A 15mm thickness. My opinion is that these will work fine on a standard breadboard or prototyping board As I like a snug fit, I like a board with a bit of give. Despite that, there are some folks out there who would disagree and say they don't like the fit or the fit is too My apologies for the late reply, but I hope that helps.
Selected User Reviews For Screw Terminal Block Kit 5mm Pitch 2, 3, 4 Pole (40 pcs) by QSU
The pins on these boards are too wide to fit on solderless breadboards, resulting in damage. There is a specification that reports this width to be The batch I got has 0 mm, which may indeed damage a breadboard.
The batch I got has 0 mm. The width of the pins on my breadboard are 59 mm, according to my caliper. As you can see, this is A ruler is directly underneath the product in the image of the terminal blocks which shows a 59 mm width.
These would be five stars, but I take one away because the specs are substantially inaccurate. It may seem like 0 mm, but it's in fact 0 mm. The diameter of the 59 mm diameter.
It works well for them. A set of i2c relays is connected to the wires attached. There's a little bit of an odd sizing for use with pinout boards that results in a 4/5 rating. It would be useful if I could Rather than only the +/- in lines, I need to do it across rows as well The table is made up of four columns and takes up Therefore, yes, buy them. However, if your space is limited, you might want to think twice.
As soon as these devices are rammed into a standard breadboard, the contacts in the sockets become permanently deformed, so that the wires won't grip on. Jumper wires of the right size. It is a bit annoying, as now I have two breadboards that are damaged. There would be no real use for these other than permanent mounting on a breadboard, so we give them two stars instead of one.
I like them a lot. sturdy plastic (not too hard or too soft An AC wire will hold well) and brittle. The reason I am reviewing this product is that I needed more of these and I ordered something else instead. Seeing that made me realize how good they.
I would not consider this purchase to be a great value at this price point. What's more, there are no problems with the quality. However, it has never been done before.
I used it to connect the sensor leads to the board and it worked perfectly.
You should be aware that pins don't fit on.
My sensor doesn't make a connection with the breadboard. I have spent several hours trying to figure out why my sensor did not work. In the end, it was the terminal blocks that caused the problem.
Related Products For Screw Terminal Block Kit 5mm Pitch 2, 3, 4 Pole (40 pcs) by QSU
