Keystone 209. 1 Cell Leaf Spring Battery Contact, Spring Steel, Nickel Plating (Pack of 20)
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
It comes in a box of 10 pieces. (Each piece is listed in the quantity)
Pack of 20 comes in this product.
Selected User Reviews For Keystone 209. 1 Cell Leaf Spring Battery Contact, Spring Steel, Nickel Plating (Pack of 20)
A 3D printed battery box had clips attached to it, which I used. It's just a matter of soldering a wire to the tab and snapping the clip in place afterward. You should note If you mount the plastic, do not solder it. There is a risk of damaging.
The contacts that came with the battery power tap from Thingiverse connected perfectly to the battery contacts after 3D printing. I had to apply a great deal of heat to solder (do so BEFORE mounting the contacts in any plastic part) but it worked out fine!.
Exactly the right thing for cordless tool battery holders made from 3D prints.
You can make it using different-sized coin cells to get the voltage you need with the least amount of Then I put them on a circuit board with a pre-drilled hole The amplified version.
I liked them exactly as I had hoped.
It is made from a thick metal, which makes it very sturdy. The solder takes well to it.
This is good.
The suitor must be installed before the installation takes place. They're a great little connector. The batteries fit into 3D printed housings that I 3D printed and paired with Ryobi 18V One batteries. Several reviews mention that these sauter hot when crimped and compressed, so be sure to use plenty of flux and crimp and compress before installing.