* Disclaimer: OveReview is reader-supported. We earn commissions from qualifying purchases
BOJACK EI-14 High Efficiency Audio Isolation Transformers 1:1 600:600 Ohm(Pack of 10 Pieces) BOJACK EI-14 High Efficiency Audio Isolation Transformers 1:1 600:600 Ohm(Pack of 10 Pieces) BOJACK EI-14 High Efficiency Audio Isolation Transformers 1:1 600:600 Ohm(Pack of 10 Pieces) BOJACK EI-14 High Efficiency Audio Isolation Transformers 1:1 600:600 Ohm(Pack of 10 Pieces)

BOJACK EI-14 High Efficiency Audio Isolation Transformers 1:1 600:600 Ohm(Pack of 10 Pieces)

BOJACK EI-14 High Efficiency Audio Isolation Transformers 1:1 600:600 Ohm(Pack of 10 Pieces) BOJACK EI-14 High Efficiency Audio Isolation Transformers 1:1 600:600 Ohm(Pack of 10 Pieces) BOJACK EI-14 High Efficiency Audio Isolation Transformers 1:1 600:600 Ohm(Pack of 10 Pieces) BOJACK EI-14 High Efficiency Audio Isolation Transformers 1:1 600:600 Ohm(Pack of 10 Pieces)
$ 10.99

Score By Feature

Based on 67 ratings
Satisfaction
8.76
Value for money
9.23
Packaging
9.22
Giftable
9.01

OveReview Final Score

How Our Score Is Calculated

Product Description

Transformers for audio isolation that are high in efficiency
Item No. EI-14
A ratio of 11 is appropriate for voltage.
The impedance of the AC supply is 600 600 Ohms
Printed circuit board with lead-free / RoHS-compliant electronic component.

Questions & Answers

The maximum power this transformer can handle is how many watts?

A xfmr signal of this size is being transmitted. require current and voltage values that would be around a few watts at most. Asking the supplier will be the best way to determine this.

Are you sure you'll need two of these for stereo isolation? Do you mean that either side of the server can be an output or input?

The first and second statements are correct *br2 The 1 represents an equal turn ratio on both sides *br>For stereo, you need two, one for the left and one for the

Can you tell me the dimensions of the product? How far apart should I space the wires?

The size of the item is small. A 5x power. A 5x power. A diameter of 5 inches. There is a spacing of 4 breadboard spaces between the leads. A 25-inch screen

Is there a dot at the beginning of the loop?

What you were asking was whether the primary or secondary has some type of indication or mark of the winding phases. This is not the case. The easiest way to determine is to apply the a volt meter( or oscope). If you short a pri lead to a sec lead, you will find out. The voltage is increased or stays about the same, so make a "dot". Once voltage drops to zero, you become a "dot" instead of a "dot". You can see how an automated system works by clicking here ) Have fun with the transformers!

Selected User Reviews For BOJACK EI-14 High Efficiency Audio Isolation Transformers 1:1 600:600 Ohm(Pack of 10 Pieces)

The only ones you can find otherwise and the only ones that Signal transfer transformers with a great little design
5/5

When I had tried to acquire them via the supply chain people typically use to source components, either I couldn't find them via specs or those companies don't offer them. It even prompted me to write to their customer support department It makes perfect sense that they are on Amazon! I didn't think to look there first. It can be used to operate as a signal transfer transformer to trigger a device from this source.

Lyric Howell
Lyric Howell
| Sep 10, 2020
The audio isolation seems to work fine for simple Seem fine
4/5

The copper windings seem shiny, the pins matched the perfboard pitch, they aren't fragile, etc. I used them to isolate a ham radio's audio input and output lines from a usb soundcard.

Emerie Bishop
Emerie Bishop
| May 09, 2021
You did an excellent job! I like this transformer very much
5/5

This is a good tool for building isolation transformers for audio. It has the ability to deliver both high and low frequencies.

Kairo O’CONNOR
Kairo O’CONNOR
| Jul 20, 2021
I bought ten There has been one use of this product so far You still get your money's worth
5/5

A purchased 10 of them, and used 1 as an interface for recording telephone calls, and left the other 9 in a drawer for use later on It is likely voice bands are being used. It's not an ideal choice for music, but it's perfect for the voice-range range.

Cesar Myers
Cesar Myers
| Oct 16, 2020
These are great little isolation transformers! The Bluetooth receivers came in handy when combining a VU meter and a Bluetooth receiver project! The isolations on the inputs to the VU board eliminated the noise from being fed back to the line! This is a very useful part the VU board!
5/5
Camille Huang
Camille Huang
| Apr 21, 2021
I am delicately looking at you The FMR
3/5

I should have attached leads with more care since they would most likely be manipulated in the future. In the insertion world, we recommend using a continuity test before and after I feel a little delicate about this. I'll be watching them closely to see how they do.

Ember BARLOW
Ember BARLOW
| May 12, 2021
It is a difficult product to work with due to the length of the leads
5/5

The packaging is very slick, and the job they did was great. I was pleasantly surprised by the speed of shipping as well!.

Kori LORD
Kori LORD
| Nov 27, 2020
It is a simple item, but it works well
5/5

There is nothing complicated about this product, but it works exactly as it should. It is packaged nicely as well.

Kingston Petty
Kingston Petty
| Jun 20, 2021

Related Products For BOJACK EI-14 High Efficiency Audio Isolation Transformers 1:1 600:600 Ohm(Pack of 10 Pieces)