DIYmall 2pcs Hx711 Weight Weighing Load Cell Conversion Module Sensors Ad Module for Arduino Microcontroller

The four units that I bought work perfectly together with 100 g load cells and an Arduino. In addition, they are easy to set up if you follow There is no doubt this particular implementation of the HX711 is horrible. As far as I'm aware, I've received only a single board As a result, the capacitors degrade in a few hours and ultimately lead to noisy readouts. I read a 100 g range and had an average noise band of 0. For my application, I read 100 g ranges. A dose of 0. 05 g (equivalent to 11- A resolution of 1 bit). The HX711 PCB with ground planes is a much better option if this does not suit your needs, but there are other implementations that have ground planes and can reach 15 GHz The bit resolution is 32 bits.

Julio Velez

| Nov 13, 2020

I'm very satisfied with how well these things work. This might not be a new subject, but there's a lot of information about them on the internet. I am a newbie to Arduino and programming but I managed to work this out quite During the writing of the novel, I used no pre-writing process A load cell has been made. By creating my own wheat stone bridge with single strain gauges, I discovered that these will only work if the bridge is half or full. Connecting a dummy gauge was all I had to do to make it work. The wiring diagrams for using dummy strain gauges can be found on Google by typing in dummy strain gauge. The output is 0 to 2*24 there is a slight amount of noise, but it is negligible. I'd buy these again without a doubt.

Amelie Davenport

| Jul 04, 2021

This is a great With Robotshop's load cells, I'm using a 100g load. You can apply for 30g by going to www. com. There are four digits to work with A good example would be 47g. It is easy to wire an Arduino since power, ground, and two digital inputs are all it needs. For my second prototype, I have ordered two more. Add the following The second set of cards has been delivered. The fact that the pins weren't soldered when I bought the package was a minus at first, but now I see it as an advantage. The second set contains pins for "Production" devices, so I want to add wires directly to the board so I don't have to remove any existing pins.

Paisleigh Copeland

| May 20, 2021

As a result of being so rusty, it took me a while to solder them up. I was able to use a heavy hand with the soldering iron with these units. Delivered well packed in a short time.

Randy Evans

| Aug 29, 2020

I expect that it will work. Please be careful to not flip gnd and VCC or you will burn the board
In addition, there are a few short pins on one side, making it hard to solder the wires.

Lola Ewing

| Mar 31, 2021

I am very pleased with how well it worked. I fitted angle headers and hot glued the leads in place to relieve strain.

Willow Ballard

| Oct 09, 2020

The load cell is a 2T eBay model. A consistent pattern over multiple power cycles is apparent.

Marco Howe

| Aug 17, 2020

When the LCD in my scale failed, I had to replace it. It was too big to pitch. The Arduino board was hacked into this board and we had fun with it. It is not quite the same as SPI, but similar in many ways. Take a look at the.

Galilea Webster

| Jun 12, 2021