TIP41C TIP41 NPN Audio Power Amplifier Transistor 100V 6A 1 Pack
Score By Feature
OveReview Final Score
Questions & Answers
Make sure you do your calculations when choosing LEDs and resistors. For most kits with standard 3mm or 5mm LEDs, a voltage of around 2 volts is needed. An Arduino's digital pins have a maximum voltage of 5V and an output current of about 25mA, and its digital pins can be powered by a maximum current Putting this into an equation, you get The power supply must be 5V. The device is connected to 5V When you use a 220 ohm resistor, you are able to keep LED within its maximum recommended power, while using a 025A resistor is an ideal match for running the LED at the maximum recommended power.
There is one of each
Selected User Reviews For TIP41C TIP41 NPN Audio Power Amplifier Transistor 100V 6A 1 Pack
It works fine. I needed a transistor that could handle a little more power than a To dissipate the heat, you will need to bolt it to a piece of aluminum. If a resistor is not connected, do not connect the base directly to the voltage. There has been a B- voltage drop A voltage of almost 1 volt is equal to E.
In his offer he says he will send 100 pieces, but he sends one he does not deliver the entire order according to what he says, so I believe that he is not a good supplier you should be careful not to lose money when you do business with him.
Doing what is said is what it does.
Therefore, I have put too much electricity into one and caused it to overheat, but it took a while to do so.
I am satisfied with the match.
This is true. The report contains no complaints or praise.
As usual, everything was perfect.
Description of the product did not meet my expectations. An NPN power transistor, the TIP41C, is a TIP41C. This transistor is a PNP power transistor known as the TIP42C.