Alpinetech PLB12M 12mm 1/2" 120V AC LED Metal Signal Indicator Pilot Dash Light (Blue)
Score By Feature
OveReview Final Score
Questions & Answers
The mounting hole is about 10mm in diameter, and the wires are about 30mm in length.
Mine works fine when connected to the outside via the power box.
While I am unable to respond to your question, I am not aware of any threaded sections. There are two tails, each measuring about 6-inches long. 8 inches, which allowed me to easily tab into the existing leads to replace the blown LED with this superior LED, which is significantly brighter than the OEM.
I have no idea. It's important to keep in mind that this is a 120v ac device. It appears that you are using a transistor and a direct current circuit in your application. Most likely, you'll require something entirely different.
Selected User Reviews For Alpinetech PLB12M 12mm 1/2" 120V AC LED Metal Signal Indicator Pilot Dash Light (Blue)
Furnace installers installed a disconnect switch on the side of the furnace, which was fine until I had a child and he turned two, so to keep him from turning off the unit, I put a switch cover guard on it. The problem was that I couldn't tell if it was on or not, as you can see in the picture, so I installed a light on the load side of the switch, which is on if the furnace is receiving power. I can't say for sure how long it will last, but it's bright enough for my needs so far, albeit a little dimmer than I had hoped.
It's extremely simple to set up because it runs on 120 volts AC. You're finished with a couple of wire nuts. In my wood shop, I connected it to a 60 amp disconnect switch. It's now simple to look inside and quickly double-check that the main power tools are turned off.
I bought this for a 5 cubic foot Frigidaire freezer that was about 8 years old and the value for this 120 volt light that I purchased worked like a charm the green light indicates that the freezer is working all I had to do was drill out the whole put the light in and tighten it with a nut that came with it recrimped the wires and it worked perfectly I don't give a lot of reviews but what a great product it worked perfect I don't give a lot of reviews.
The goal was to have a green light so I could see if the generator was running while driving down the road (just like the big rigs do on their reefers). For mounting, I needed to drill a hole in the RV and connect it to a long pigtail. This is connected to a storage outlet that is only powered when the generator is running or when we have shore power. I mounted it so that I can see it while running down the road in my side mirror.
Because it was just a smidgeon too narrow for a standard 1/2" threaded knockout, I had to use a vari- It was a disappointment to use a bit and make a hole slightly less than 1/2" in a blank cover, but it could still be used for a radon vacuum switch/indicator, which is required by code.
For my needs, this is ideal. Installed on a black wall plate with an air actuator. It looks great and lights up whenever the air switch is turned on.
This little light was installed on my homemade incubator to alert me when the element was turned on, and it works perfectly. I would suggest it. Thank you for the prompt delivery.
This lamp was perfect for the job.